How to inject Test Prop + Mast Prop

[505]

Hi guys,

So I'll be starting a new cycle soon and I have a question. My previous cycles were test prop only. It was easy. ED shots for 8 weeks.

I'm about to start a new cycle test prop/mast prop but since I like pinning ED to avoid PIP I was wondering how should I proceed.

Should I draw individually my daily dosage of test and mast and blend them together in the same vial then inject?

Or should inject them individually? If I inject each compound by itself can I pin the same muscle twice the same day? (one from test and one mast). I only have 8 injection sites so not sure how to do this.

Sorry for my english and for the noob question.

thanks

[Buster Brown]

I would mix them together in the same barrel and inject. I haven't had a problem pinning glutes, quads, or delts with 2.5 cc's. No need to split, just wasting injection sites in my opinion.

[505]

do I have to draw from each vial separately, mix them together in an empty vial then draw the mix in the syringe? how do you guys do it, it's tricky

[austinite]

No. Just draw one, then the other.

[kelkel]

Draw with a different pin than you inject with....

[Bert]

One syringe.

[505]

No. Just draw one, then the other.

How can I make sure I'm getting the right amount if I do it that way?

Wouldn't be better to draw each compound by itself, put in a sterile vial then draw the mix? It takes more time but at least I'm sure everything is done right.

My stuff just got here today

[austinite]

How can I make sure I'm getting the right amount if I do it that way?

Wouldn't be better to draw each compound by itself, put in a sterile vial then draw the mix? It takes more time but at least I'm sure everything is done right.

My stuff just got here today

That's a lot of unnecessary steps.

If you need an ML from each vial, put air in each vial, draw 1 ML from one vial, then another ML from the other vial. into the same syringe.

Make sense?

[Mp859]

How can I make sure I'm getting the right amount if I do it that way?

Wouldn't be better to draw each compound by itself, put in a sterile vial then draw the mix? It takes more time but at least I'm sure everything is done right.

My stuff just got here today

Simple addition will give you the right amount of each compound. You are making it way more difficult on yourself.

[AlphaMike]

How can I make sure I'm getting the right amount if I do it that way?

Wouldn't be better to draw each compound by itself, put in a sterile vial then draw the mix? It takes more time but at least I'm sure everything is done right.

My stuff just got here today

Not too complicated man. Example:
You want 1 ML of each compound. Draw 1 ML of test, draw 1 ML of mast. The measurements should be on the side of the syringe. You should be sitting at the 2ML mark. Now change out the needle and inject.

[505]

Alright you guys are the best thanks!!!!!