question about solution

[shaunjohn242002]

ive got a bottle of teste 250 and it had crystals in it, i heated it up and shot it, no prob. next shot a few more crystals, did same thing no prob. the crystals are getting thicker though. how hot can i get the solution before the test is destroyed or the bottle breaks? i use a 22g needle to draw. id like to avoid adding more oil in it for several reasons. im afraid im going to end up using all the oil and not getting all the test. any other simuliar expereinces?

[bass]

did you brew it your self? usually boiling would take care of it, but if its getting worse then its time to toss it.

[shaunjohn242002]

no i didnt brew it. ugl. good stuff though. havent boiled it. just warmed it

[Lunk1]

I have some cyp that crashes all the time and I just heat it and pin it. You are not bringing it to a boil or anything. Just warming it up a bit will not hurt it.

[bass]

^^^ do not boil the oil, only the water then dip the vial in the water after you turn the stove off

[Bonaparte]

You don't need to worry about damaging the test. You'll blow the top off the vial before that happens.

[shaunjohn242002]

thanks for the replies, if oil runs out and crystals are left should more oil be added to get the rest of test? would it solute? i really hope this wont be the case cause i dont think i could know the mg i am shooting. im not experienced in this part of the game so sorry if questions are stupid.

[bass]

you shouldn't draw if you see crystals, and if you get rids of them by heating eth oil then you shouldn't have any left.