Injection question

[Jb818]

When you inject into the quad do u put the needle in all the way and then aspirate or do u have a little bit of the needle showing and then aspirate , or does it not matter either way?

[Bio-Active]

When you inject into the quad do u put the needle in all the way and then aspirate or do u have a little bit of the needle showing and then aspirate , or does it not matter either way?

depends on the needle size. Leave a little out if you can and yes always aspirate . The idea is that if the needle breaks it's easier to fish out than if it's buried under the skin

[derekkpapa1]

^^^^ good info I just push all the in quad and go never though otherwise.
I guess pin must of broke on someone at some point and if it was buried would be tough.
Op what size pins you using

[ForumMember]

I have found the 1 1/2 inch 23 gauge to be the best for me...

[Jb818]

thanks guys

[Jb818]

i use a once inch needle btw

[DontTaseMeBro]

its purely psychological, but the 1 1/2" needles just look like freakin' harpoons to me!

[Bio-Active]

its purely psychological, but the 1 1/2" needles just look like freakin' harpoons to me!

Yeah and depending how lean you are you may or may not have to go that deep. I never do

[austinite]

^^^^ good info I just push all the in quad and go never though otherwise.
I guess pin must of broke on someone at some point and if it was buried would be tough.
Op what size pins you using

If the pin broke (not sure why it would), it would come out on its own, not get buried.

[Red Bastard]

How does a needle break?? I've tried, doesn't work. I sink it all the way in, that way it's more likely to stay where I asperate... If aspiration is even necissary...