Oil left in the needle

[n1x0n]

My last cycle I pinned 250mg e5d. After the first two injects I noticed that it was left some oil in the amp head and needle so I started leaving 0.2cc of air in the amp and injected it so all the oil would come. But it sort of looked like some oil was still left. Should you just don't care or is it some other way to do it?

[PT]

Leave a little air at the top of the syringes if your worried. Personally I just push hard then toss it. I'm not worried about a little oil

[Baxter35]

Inject a little air if you want, but overall not worth worrying about.

[clarky.]

Leave a little air at the top of the syringes if your worried. Personally I just push hard then toss it. I'm not worried about a little oil

Inject a little air if you want, but overall not worth worrying about.

This ^^ don't bother about it

[n1x0n]

But if you inject 250mg and like 0.2cc gets left in the syringe then it's only 200mg that gets in the muscle? Or is it much less that gets left behind?

[Oki-Des]

Dont worry about the oil that is left over. I think you will have more problems if you start injecting air into your muscles by accident.

[n1x0n]

By accident? I've been doing it on purpose for 10 weeks...

[Bonaparte]

I think you will have more problems if you start injecting air into your muscles by accident.

Hardly.

[lovbyts]

But if you inject 250mg and like 0.2cc gets left in the syringe then it's only 200mg that gets in the muscle? Or is it much less that gets left behind?

Dude do this. After you inject like normal pull out, pull some air into the syringe and then push out the oil that is left. You will have a drop or 1 1/2 at the most. Its ot enough to worry about. Maybe 2mg at best.

[Oki-Des]

Well, it is not like you are going to get an infection from injecting air. But, injecting air can cause additional soreness and bruising, that is worse than simply leaving a tiny bit of oil left in the syringe during injecting.

[Red Bastard]

I always inject plenty of air. Never get pip, or any sort of bruising...

[chris.baker]

I pull some B2 first, then the oil. So only thing left in the pin is a droplet of B2. I don't do it for that reason... just how I've done it. I wouldn't worry about that tiny amount. .2? Probably more like .02 left if that.

[DrewZ]

I'm getting pretty good at leaving just the right amount of air so that I push all the oil out.
Once in awhile I will hear it inject a little air at the end, no worries tho - never had a problem.