What do 'settled' crystals look like?

[C3RB3RUS]

I have vials that have little wispy structures floating in them. The structures resemble cigarette smoke. there are about 2 - 3 in a few of my vials that contain DECA and TREN. i don't remember seeing any in the testosterone vials. should i give the bottles a shake to see if they go away? have the crystals gathered? the vials have been sitting for a few months. i know the crystals can gather. the vials are un-punctured and they've not been exposed to very high, or extremely low temperatures.

[600@50]

They may have crashed or it may be bacteria growth. Heat them up and see if the stuff goes away. If it's trash or bacteria just toss them. I have used a heating pad to heat vials. It works well and no chance of any moisture.

[C3RB3RUS]

i'm heating them carefully now.


well they are all warm to the touch, but not close to hot and far from burning.

Both TREN vials have reformed the wisps that look like smoke, or spider veiled webbing. i also believe that one vial of a Testosterone i popped has traces of this veil stuff.

All i have left are 2 10ml vials of sus 250 and a 10ml vial of DECA. they are clear.. f_ck my life.

this f_cking shit was soo damn hard to ****ing find... and i don't trust the internet. i was stoked. i was going to 'go on' right after late May, early June time frame. F________________CK

I've 'slightly' elevated the heat. how many hours should i leave this stuff to warm?



ok, it's been 1 hour, or close to that. i shook the vials up and then placed them back on my heating pad. the veils are not reforming, but it's seems to be obviously because i shook the vials. i'm going to leave them on the pad over night. the TREN is the only substance that isn't crystal clear. the other Testosterone is crystal clear. i'm still observing them.

is there more observation that needs to be done? -on second thought, i've taken them off the heat and am now still observing them. now i will wait to see if the veils reform, or grow larger. there is no condensation in the vials.

i'm going to inject them in some time if nobody weighs in.


stand by for good photos!!!!

[C3RB3RUS]

boom

This good enough?

Can i have an ADMIN move this whole Mother Lovin' thread to the Brewing section?

[kelkel]

Not uncommon especially if the mg's per ml are higher than normal. Warming it should correct the issue like 600 recommended.

[C3RB3RUS]

you are awesome! Thank you.

[lovbyts]

You mentioned a heating pad, is this how you heated them? What's worked for me in the pas is boil some water just a couple of inches deep. After it starts to book turn off the heat. Now place the vials in the water and leave but them for at least 1 hr.

[lovbyts]

BTW crystals from crashed gear look more like half melted sugar particles stuck on the side of the vial but what you have is still considered crashed or separated and heating should help.

[Bonaparte]

Different products will look different when crashed (just as the raw powders have different appearances, textures, etc).
I've seen large crystals, small crystals, gel, frost, wispy powder that settles (tren), etc.