Debris in my test

[Synhax]

Just noticed my test-e bottle now has some debris most likely from the rubber cap, they weren't there when i was doing my last injection. Solution still clear though, so im guessing its still ok to inject? I still have 6ml in that bottle, im really hoping there isnt going to be a contamination.

[< <Samson> >]

Know what you are shooting

Let me know how it goes if you get one of those turds lodged an inch in your muscle


I filter questionable gear, but stopper I just chase around with the spike in various ways.

[djgreen]

just stick in a clean needle and slightly draw it out you wont waist much if your careful and it will be fine the rubber came from inside so its clean just make sure the needle goes in straight and in the middle of the rubber next time because it is thicker towards the outside

[lovbyts]

What size pin are you using to draw? I know some people like to use 18g because its fast but I use a 21g and I can draw 3cc in 30 seconds so thats fast enough for me. Some rubber stoppers seem to be of lower quality than others. I have seen where you can put a pin through it 10x and not see a single hole and other times you can see each pin mark. Another reason to make sure you vials stay upright and IMO keep vacuum in them so they dont leak.

[PT]

18g needles can do that especially with ugl gear. I would filter it. It's happened to me before but it's been a while

[Synhax]

Yep been using 18g to draw, maybe its too big? I can try 21 gauge or even 23 and see if that will prevent it from happening in the next vial i use. This rubber cap is definelty not good quality, i see most of the holes i made. I make sure to wipe the top clean with alcohol pad after use and place in a closed container, hopefully that will prevent any issues. So far, I only notices a few pieces in the solution, all from the rubber cap, so hopefully no harm done.

[Synhax]

18g needles can do that especially with ugl gear. I would filter it. It's happened to me before but it's been a while

How do you filter?