delt pin and oil dispersion

hi guys

when you pin the medial head of the delt - is it possible for the oil to disperse into the side part of the arm?

from what i understand pinning underneath the medial head of the delt shouldn't be done - because this is a dangerous area to do so?

i basically pinned the medial head and now have agonising PIP (my supplier has very high BA content - which I've now binned). However, the PIP is not in my delt, its on the side of my arm underneath the delt! lots of redness and pain.

am i in danger? is there anything i can do?

goddam you dure pharma


thanks guys

Any swelling at the site?....fever?...how long has it been since your injection?

Not really any swelling I don't think. It's just hard and painful to touch. No fever. I injected this on Tuesday and today I guess it's a tiny bit better then yesterday but the redness is still the same (the pain has slightly reduced since yesterday)

I injected today 13 hours ago using a different source and the area is fine. The EXTREME PIP must have been caused by too much BA in the stuff I was using before

Keep an eye on it. I agree that its most likely the BA content that was used in the conversion. Good ta know that the pain is decreasing.

Yea. If it's getting any better you most likely will be fine in a few more days. Bad PIP is tough.

You might have missed the muscle and it leaked out. No danger you will absorb it but this is always a problem with higher bodyfat because you don't know what size pin to use.