Printable View
I pinned today with a total of 3cc (1cc test, 1cc tren, 1cc EQ) and while I'm pushing in the syringe to inject the oil, the oil spills in to the syringe. I finish pushing all of the oil in and remove the needle and there is a decent amount of oil still in there, but it is above the plunger thing. If I tilt the syringe upside down the oil spills out. How do I prevent this from happening again? Am I injecting too quickly?
It sounds like a bad seal on the plunger, the seal is not keeping the oil below it.
I also would say bed seal but if you have a 3 ML syringe and you put in more than 3 ml it can happen often. Might want to go to the 5 ml syringe.
Definite bad seal
3cc is for horses! But change the syringe brand
3cc is definitely not for horses (actually male bodybuilders prob take in more AAS then horses do). 3cc is not a lot. lets say you were running 700mg test prop, 600mg tren a, 800 cc primo.. thats 21 cc per week just right there (with only 2g of gear). a 3cc syringe is a minimum for guys that run actual cycles and not just on TRTQuote:
Originally Posted by matri.x
Use a better brand syringe/pin combo,,,I like the B-D brand.Quote:
Originally Posted by bsblltom