heat the oil (test enth) in amps

[fabry]

how do you heat the oil for easier injections?
i was thinkin that maybe is better to heat the oil in the syringe (ready to be used) coz if i heat directly the amp, before i open the amp, i draw the oil and i get ready to inject it will go back to normal temperature...
what do you think?
if i heat the loaded syringe under hot water, will it be safe for the needles (should i leave the cap on it).
thanks

[fabry]

c'mon guys!!!

[Agent Smith]

Hi Bro

I always heat the amp in a cup of hot water. If you drawing it out with a 18g needle it only takes a sec. It all depends on what enanthante you have. my friend heats his up in the syringe with the draw needle and then puts a 23g 1inch pin for his injection. that way if you get water on the needle it's only on the draw pin not the one your injecting with.

peace

[fabry]

good boy, great advices! just needed to "use my brain" a little bit more...
my test is iranian test enanthate...

[snoopydogj]

I run it under hot water in the syringe for about 1 1/2 min for 3 cc's

[fabry]

i think ill just draw into the syringe, heat it under water with the drawing needle and then change this one right before injecting.
thanks

[pinhead]

I didn't know you had to heat it also why would you is it thick? just curious bro

[fabry]

i think is just a scientific trick... if you heat a oil, it becomes more fluid and easier to inject.
not necessary...

[asiancuts]

yes, heating it thins the oil out. i usually run my amps of testoviron under hot water for less than a minute until when i shake it around it looks really watery, then draw and inject.