Brown spot on inside of tren vial..

[No One Knows]

My vial of tren got all used up yesterday, so I busted out some more to continue my cycle. I drew a cc this morning and injected into my quad.

About 5 minutes ago, I looked at my vial and I can see something on the bottom of it. Its a dark brown spot, stuck on the bottom of the inside of the vial. It wont come loose or anything..I can swirl the juice and it stays there.

It definitly wasnt there when I converted the fina, or days after... My other vial also looked like it was a different color. This one looks a bit more cloudy. I used 2 different companies conversion kits though, so I didnt know what to think..

Anyone know what this is? It looks like it could be bacteria growth...Shieeeeeeet.....

[MBaraso]

That happens to me everytime I've used fina. I just heat it up once in awhile, once I even added a tiny bit of ba just for good measure.
Never had a problem with it after that.

[Mesomorphyl]

Could be oxidation... I have seen smaller little ones after baking and bigger ones from 40ml kits. May also be due to the filler... Should be ok, even if you get some swirlies in the bottle after swishing it around.

[No One Knows]

So its not bacteria?

And when you say heat are you talking oven or warm water?

Thanks

[Mesomorphyl]

I meant oven at 250 deg for 30 minutes with a pin in the stopper to let off the air inside the vial

[No One Knows]

Could be oxidation... I have seen smaller little ones after baking and bigger ones from 40ml kits. May also be due to the filler... Should be ok, even if you get some swirlies in the bottle after swishing it around.

I used a 40ml kit and I only get some air bubbles when I swirl it. I didn't heat at all when I made it...

[almostgone]

I used a 40ml kit and I only get some air bubbles when I swirl it. I didn't heat at all when I made it...

...Shouldn't have to bake it..A hot water bath may do the trick....

[MBaraso]

...Shouldn't have to bake it..A hot water bath may do the trick....

That's what I meant by heating it up. Should have been more clear i guess.

[No One Knows]

I just ran it under a hot water bath for about 5 minutes and the spot stayed. It appears to have a more reddish tint now...

I guess I'll see how my leg feels tomorrow...

[almostgone]

That's what I meant by heating it up. Should have been more clear i guess.

...Lol, didn't mean you, MB... I was referring to the suggestion to heat it @ 250 degrees for 30 minutes..

[block]

you dont have to do anything all it is, is broken down oxidized filler that made it through the filter that then settled out if the tren it wont hurt you in any way. the oxidized filler is what sometimes gives tren its more amber color.

[almostgone]

I just ran it under a hot water bath for about 5 minutes and the spot stayed. It appears to have a more reddish tint now...

I guess I'll see how my leg feels tomorrow...

..The reddish tint happens with pellets sometimes...Haven't had it happen with powder...

[No One Knows]

you dont have to do anything all it is, is broken down oxidized filler that made it through the filter that then settled out if the tren it wont hurt you in any way. the oxidized filler is what sometimes gives tren its more amber color.

Thanks guys. I thought for a second that I might have had to scrap 40ml of tren.