****ing oil leaking out after inject?

[statuZ]

okay bros this has happened to me 3x (note this is out of 6 weeks of shots ED) but WHY THE HELL after i inject in my shoulders sometimes does it FUKING LEAK OUT AFTER? I try to let the needle chill in there for a few seconds before i pull out. BTW im injecting 3ml ED, and when that shit leaks out it looks LIKE A GOOD AMOUNT. Im about to go pin again my right shoulder because of this probably.

[statuZ]

btw it was not a small amount, it fuking dripped down my shoulder! this is so frustrating wasting juice like this its unreal. i cant do the z-track technique by myself when injecting shoulder. Should i have left it in for longer?

[Kale]

What size pin are you using in your delt ?

[bolin]

bump!

[magic32]

Z-track it!

M.

[WEBB]

it may look like a lot is leaking tou but i doubt that you really are losing that much at all....i get it sometime, all i do is make sure the needle size is right, try and move injection sites so it has more time to heal, or try and move the site by just a little in your delt...

[scottroxx]

You could be shooting the stuff in to fast, when you are done leave the needle in for a minute and have a sanitary wipe ready when you pull it out, when needle is out, apply pressure immediately for a minute or so. That's what i do and never have any leakage afterwards. Also, you say you shoot 3 cc's in your shoulders?? Unless you have mammoth shoulders I wouldn't do anything more than 2 cc's it ( gear ) all wont be absorbed as the muscle area is too small !!! I have almost 60" shoulders and I will only do 2 cc's.

[SMAN12b]

Well if I new anything about this stuff, i might suggest that before you inject, you need to pull the top layer of skin over just a bit and hold it there while you inject then let go. When you pull the needle out, the skin will stretch back to the original position THUS covering the injection hole and NOTHING should leak out.....but than again, I am too stupid to know anythign about this stuff.....sorry I couldnt' help

[magic32]

Well if I new anything about this stuff, i might suggest that before you inject, you need to pull the top layer of skin over just a bit and hold it there while you inject then let go. When you pull the needle out, the skin will stretch back to the original position THUS covering the injection hole and NOTHING should leak out.....but than again, I am too stupid to know anythign about this stuff.....sorry I couldnt' help

Sounds familiar...oh yeah, two posts up:

Z-track it!

On point as usual Sman!

M.

[Lavinco]

Make sure you are going deep into the muscle and inject slowly.

[SMAN12b]

Sounds familiar...oh yeah, two posts up:


On point as usual Sman!

M.

Well i figured he may need an explanation of what Z tracking was since he is leaking ALL his juice....but hey, I am just a dumb white guy.....lOLOL

[Dangerdan]

Applying pressure to the site for 60 seconds or so immediately after you pull out took care of this problem for me.

[Moe-mentum]

Also, when the pin is almost completely out of the muscle, begin to Z track it, pulling the skin over to the side and completely Z track it once the pin is removed for 60 seconds.
Seems to work for me.

[statuZ]

I cant z-track and inject with one hand? Do you guys have 3 arms or is it just me? Should i move my delt muscle right after i inject, like push it in a different way? Pull it out in a different direction? can someone explain more? I think i may need to leave it in longer (just cause its 3ml in my delt, 25g 1" fyi).

[boxingbean]

2 ways to avoid leakage, not a big deal IMO tho...

1. strectch/pull ur skin away from ur injection site, inject, then when pullin out, ur skin will go back over the injection site

OR

2. right after u pull, stick your swab of alcohol on injection site to help close hole...

[Moe-mentum]

Lol, yeah, I guess it would be kind of difficult.
I only had my first gusher today in my quad and it still wasn't even all that bad.
Other than being very prepared with the same hand to have something to apply pressure with as soon as the needle comes out what else can you do besides inject where you CAN use both hands?

Good luck.

[Pieru]

Keep needle about 10seconds after injecting in still.And then pull it out.This worked for me

[statuZ]

last night shot my right shoulder, with very minimal leakage(3ml total of tren/prop/npp).
With my left hand i move my skin over a stuck the needle in, when i had got the needle i let the skin relax. After i was done injecting i had let the needle rest in my shoulder for an additional 30 seconds without moving it.I pulled out and there was a little bit of a leakage so i moved my skin and put an alcohol pad on it (very minute amount came out, not enough to even notice). My shoulders were always fine shooting 1.5-2.3ccs but 3ccs seems to be a trick.

[hippie1171]

When you inject a large amount into a smaller area you are more prone to leaking, especially if its a smaller length need, but your needle size looks good to me. Have you tried rotating your injections the same day (1.5ml in each delt R/L). How about shooting R/Delt-1.5ml & R/Tricep-1.5ml. I shoot .8ml with a 22g 3/4in needle in my delts and tris with no problem. Also, if you wipe with an alcohol pad quickly then put pressure with a finger for about 30secs-1min you shouldn't see much if any leakage at all.

[statuZ]

1.5 in each delt wont work for me. I rotate each muscle group a day, so today i worked legs (tonight ill pin right quad, tommorow ill pin left quad). It usually goes like this
whatever tricep
right quad
left quad
right glute
left glute
leftshoulder
rights houlder

if i get needy ill bust a chest inject or a lat inject but id prefer not to.

[magic32]

Be sure you're not overusing an inject site (not bodypart, but specific site), this can cause scar tissue which WILL push some oil back out. In extreme cases, many have reported difficulty penetrating the skin, and on occasion a ripping sound during insertion.

M.