I just took my first shot of sus 250 and had a hard time getting the sus in the syringe. I wasted more gear then need be b/c it took like 10 minutes to get 1cc out the bottle. Any suggestions?
New Member
I just took my first shot of sus 250 and had a hard time getting the sus in the syringe. I wasted more gear then need be b/c it took like 10 minutes to get 1cc out the bottle. Any suggestions?
Educate B4 U Medicate
What size needle did you use?
Was it a vial with a rubber stopper or an amp?
If vial, did you first add air in the amount you were drawing to create pressure to make it easier to draw?
I usually draw with an 18g needle and shoot with either a 23-25g
Anabolic Member
draw w a larger pin
New Member
it was a vial with a rubber stopper and the pin was 23 gauge
Anabolic Member
should not be too hard w a 23 g...
Educate B4 U Medicate
Originally Posted by the virus
Well that could be your problem then. It will take longer with a skinny needle cause the oil is thicker. couple things to try
1. warm up the oil in a cup of hot water
2. get larger needle 18g works great
3. inject air into the vial in the amount you are drawing to help create pressure to force the oil a little quicker
either way take your time and be patient. good luck and WELCOME TO AR
Banned
I used 18 g but sometimes it took off part of the stopper and dropped into the liquid.. I will try 21g from now on..
Associate Member
Even a 21g with air pushed in loads pretty fast.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote