Stickin Needle Through Vial

[gymrocken]

hey all,
id like to know more about using a vial and how to stick the needle in it.
most are plastic, so you stick the needle in and draw out solution. but then you have a hole in it? and for rubber stoppers too, wont you have a hole in them too after stickin needle through? do you just "re-use" the hole for future needles?
i usually used amps all.
future thanks for answers!

[fLgAtOr]

Plastic tops are suposed to come off, exposing the rubber stopper....or so I thought.

Its a dense rubber, so the small needle hole sort of closes up after you pull the needle out. I just wouldn't recommend using an 18 ga needle...Then it starts to get large enough to leave holes or put rubber into your mix.

[c8rsa]

Remove the plastic top to reveal rubber top. When you draw from the vial its will cause a vacume inside.This will stop gear leaking out and also the rubber hole will close as u pull needle out

[CS1400]

I use a bigger needle tip to draw it since the smaller ones won't work (just won't pull thru the smaller tip) and then twist it off and use the smaller tip to inject.

[frank12391]

I draw air too to create a vacume in the vial after use. Before I am ready to draw oil, I pump 1 cc to create pressure which help to draw the oil out. As the vial gets less and less oil, you get more and more air so sometimes you need to draw some out with a clean new pin ofcourse. (Never stick a used pin in your) vial

[NO LIMITS]

Draw back and shoot air into the bottle about two or three times. Pull the needle back into the juice and let go. It will fill itself. It is usually always faster that way. Never had any problems. Try injecting after you have stuck through the plastic cap! Just joking.