Juice wouldn't shoot...

[lpicken]

Just did my first shot yesterday and it was alot like the first time you have sex: nervous as hell and over way too soon. Anyways, once I got the needle in my quad, the juice didn't seem to move even though I was firmly pressing on the plunger. I was using 1 cc. of sust. 250 with a 22 gauge 1" needle. (All I could get from the local feed store.) Like a dumbass, I forgot to aspirate and I think that was part of my problem. I eventually pulled the needle back about halfway and I was able to get the gear inside my thigh. Has anybody else had this problem and if so, do you have any tips?

[Swifto]

Just did my first shot yesterday and it was alot like the first time you have sex: nervous as hell and over way too soon. Anyways, once I got the needle in my quad, the juice didn't seem to move even though I was firmly pressing on the plunger. I was using 1 cc. of sust. 250 with a 22 gauge 1" needle. (All I could get from the local feed store.) Like a dumbass, I forgot to aspirate and I think that was part of my problem. I eventually pulled the needle back about halfway and I was able to get the gear inside my thigh. Has anybody else had this problem and if so, do you have any tips?

I have had this in my right quad. Usual sort of location to inject, same compound, same size needle etc...AS just wont come out. Need to pull out and start again. Woulsnt worry about it. It happens.

Few tips...

If your using amps, I heat mine in hot water for 5-10 minutes before injecting. The oil flows better and pain in the following days is less.

Massage the muscle for 3-5 minutes pre-injection.

Inject slow taking 1-3 minutes per 1ML. Then leave the needle inside for a further 1-2 minutes after injecting, keeping it very still (helps me with pain in floowing days).

Massge the area for a further 5-10 minutes.

I often shower after injecting and massage the area again for 5-10 minutes and place a warm shower head over the injection(s) site whilst massaging in this 5-10 minutes.

*If pain then follows in the next 1-5 days place a heating pad on injection site(s) for 30-45minutes. This, I find, helps a lot.

[Primalinstinct]

If you have the time, take a bath intead of a shower a couple of times. It helps the muscle even more. Streching may help, as well as relaxing before pinning should be mentioned, too.

[GHO5T]

I have had this in my right quad. Usual sort of location to inject, same compound, same size needle etc...AS just wont come out. Need to pull out and start again. Woulsnt worry about it. It happens.

Few tips...

If your using amps, I heat mine in hot water for 5-10 minutes before injecting. The oil flows better and pain in the following days is less.

Massage the muscle for 3-5 minutes pre-injection.

Inject slow taking 1-3 minutes per 1ML. Then leave the needle inside for a further 1-2 minutes after injecting, keeping it very still (helps me with pain in floowing days).

Massge the area for a further 5-10 minutes.

I often shower after injecting and massage the area again for 5-10 minutes and place a warm shower head over the injection(s) site whilst massaging in this 5-10 minutes.

*If pain then follows in the next 1-5 days place a heating pad on injection site(s) for 30-45minutes. This, I find, helps a lot.

Damn bro, thats alot of work to go thru just for injecting, thats like 25 minutes minimum lol