Heating the oil for easier injection

[HRTC]

I am currently heating my sust 250 amps before I shoot them so they shoot a little smother. I use a little water heater. I bring the water up until it starts to steam then throw the amps in while I am preparing to inject. I leave the amps in the water for about 1-3 min. My question is, can the heat from the water ruin the molecular structure of the test and make it no good if left in for two long of a time?

Thanks

[kwakisaki]

yeh i do the same,but have u has the sus flu?

[HRTC]

yeh i do the same,but have u has the sus flu?

No sust flu. Everything is working out great. Just curious if I lessened the grade of the synthetic test by heating it.

[BOOST]

I use a blow dryer

[bigwillystyle]

im pretty sure your not scwrewing it up..
i'll do some checking, you can sterilize most homade test,tren..@ 250 degrees for a few minutes.

[HRTC]

Just currious if it will degrade beacuse of the heat?

[Weegiebol]

Every chemical will degrade if the heats high enough, but you should be ok as long as the water is only warm mate. I normally draw my gear into the syringe, then put it on top of a hot water bottle or radiator for a minute or so, that way the stuff is nice and warm as you're actually injecting. It's taken away a LOT of the pain I was getting with my shots.

[HRTC]

Every chemical will degrade if the heats high enough, but you should be ok as long as the water is only warm mate. I normally draw my gear into the syringe, then put it on top of a hot water bottle or radiator for a minute or so, that way the stuff is nice and warm as you're actually injecting. It's taken away a LOT of the pain I was getting with my shots.

Thanks for the info

[Njord]

Thanks for the info

Water boils at 212 deg, so even if you put it in boiling water it wouldn't ruin the hormone. Of course you wouldn't want to inject a solution that is heated too high.

[nalbano34]

to avoid that just stick the vial/amp into your pocket for about 15 mins., works great for me.

[helium3]

Just currious if it will degrade beacuse of the heat?

its fine your body runs somewhere around 98.6f,so no worries there.

[briancb1]

I no longer heat it up.

When the solution is thin, it comes out easier when you pull out the needle. And yes I really take my time doing the whole process. When I leave it room temp and thick, nothing comes out - just the way I like it.