HELP!!!! did i do it right

[bbminded]

ok i just finished my first satchet to sterile vial transfer. i learned the hard way never to use a 23g needle and get some 18g nest time. ok heres what i did. i swabed the stachet with rubbing alcohol and stuck the pin into the corner and pulled back on the syring. i did this for a few cc s and then it just got to hard. also to let you know i was drawing from a 20ml satchet. i also swabbed the top of the 20ml sterile vial with alcohol as well. well i got frustrated as it wasnt working that good so i got some scissors sterilized them and cut a slit in the top of the satchet stuck in the needle and pulled it all out this way. it worked better but still took forever. the shit was thick as hell. does it sound like i did it ok. also i did get air in the vial when i was transfering but dont thiink that will cause a problem. what you all think????

[nbkandrew13]

i think youll be ok although i would have soaked the sachet in alchol

[Snrf]

should have injected some air into the sachet, and air in the vial won't do anything its fine

[Snrf]

let it sit for a week, the BA will kill any bacteria picked up inside of 1 week

[bbminded]

really i didnt know that i have another satchet of primo but im def getting some 18g needles from here on out. it was torture

[Aussiemuscle]

really i didnt know that i have another satchet of primo but im def getting some 18g needles from here on out. it was torture

easiest way i found was cutting the top of the packet with a sterile pair of scissors and withdrawing it with a 20ml syringe without needle then put a fresh needle on the larger the better(wipe down the end of the syringe with swab before you put theneedle on cause if you put the needle on the end of your syringe with oil still around the edges the needle will pop of the end as soon as you apply pressure and your gear will go everywhere talking from experience "not good" then pre load 3ml syringes with what ever dose you plan on having throuout your cycle or store it in the 20ml syringe i dont know if this is the best way but this is what i have done and found it the easiest and quickest way to do such a boring prick of a job

[BuffDJ]

Everything sound good. I can see using 18g to draw it out of the packet but don't stick that in the rubber plunger of you vial. Also a great Idea is to but a 23G pin in the vial then when you inject you AAS into the vial it will vent. Keeps from building to much pressure in you vial.
Good Luck
Buff