Winny Injection Question

[toolman79]

My buddy is running winny in his cycle. Today he tried to use a 1 inch, 23 gg to the shoulder. He didn't use the full inch. Anyways when it was time to push the winny the plunger wouldn't go. Why is this and whats needs to be done to make it go in smooth? Also what size needle should he use for the shoulder, glute, and thigh? He's pretty lean.
Two questions for the winny injection users. Thanks.

And no he's not just running winny; he's running winny and test.

[toolman79]

no help?

[Amorphic]

sounds like the winny is poor quality and plugged the pin.

hes going to have to move up to 22g pins and see if that helps.

higher quality winny can usually fit through a 23g pin no problem.

delts ands quads should be 1" pin, the guage is going to be whatever allows the winstrol to go through.

[binder]

make sure you shake it up really good. also, after you draw it up, roll the syringe around a bit to mix it more right before you inject.

like stated, you might have to use a 22g. I had no problem with 23g though.

sometimes the needle could be in a bad place. i've had them stick a couple times, pull back and aspirate (which you should anyways) and that might make it move a bit. if not, pull out and find a new site.

[redz]

I had this problem with winny injections. Sometimes it would go through the 23g sometimes no, I also had 22g, Winny can get clogged up not good and I`ll never do it again. i found it woudl be stuck but I could eventually get it un-clogged but it would shoot in way too fast causing further discomfort. Good luck try a 21G pin.