How do i change tests on cycle

[anabolictonic]

Hi boys i have a dilemma. I only have enough test enth left to see out 8 weeks of my 11 week test enth cycle. I only just started week 5 and contacted my supplier to get more test enth and he has told me he only have test cyp and test prop available. How would i switch from test enth to test cyp - Would i have to start shooting the test cyp 3-4 weeks before the test enth runs out? Im thinkin not because test is test but im not entirely sure... Could i just run the test enth till i run out and then start shooting cyp or would it cause my test levels to drop heaps and then take a while for the cyp to kick in? Also how would i run the process if i switched to prop? Im thinking i shouldnt need to start shooting both tests at the same time - id just start shootin test prop ed 3 days after my last test enth injection. But im not sure ..

[WARMachine]

First off, the rule is, NEVER EVER start a cycle without ALL your gear or PCT items.

Now you know why bro...

Anyway, id just shoot the Prop. Its easier, not to mention that short esters rock, and you could begin PCT a few days after your last Prop injection.


Whats your proposed PCT.

[warchild]

not really a dilemma man, just grab the cyp and use it as you would the enan. the test is already running through you, so it should not need time for the cyp to kick in

[anabolictonic]

thanks ... Nolva n proviron for 2 weeks then nolva for another 2 by itself

[nhl1]

yah just pump the cyp in replace of the enan. I doubt you'll even notice a difference.

Everyone says "all gear all pct first," but, we all know thats not always practical.

[WARMachine]

^^ And then people wind up in this situation...

Its called thinking ahead.

I would run the Pro for 4 wks too and maybe throw in clomid in a low dose around 25mgs ED...

Other than that best of luck bro!

-WAR

[anabolictonic]

thanks... i had what i wanted for my initial cycle which was goin to be 10 weeks @ 500mg pw... but decided 2 front load and also extend the cycle - i no i shoulda had my plan set in stone b4 i started the cycle but thats just the way it went - i'll no for next time

[anabolictonic]

if i were to switch to the pro tho... would i just start injecting that ed, 3days after my last test e shot or should i wait like a bit before i start shootin the prop?