Oil comes out after injections

[Frankie4Fingers]

sometimes oil comes out after an injection...i usually shoot with a 27g 1/2" or 25g 5/8" in small groups (delts, biceps, triceps)...too small pins?

[Matt]

Cool isnt it...

[LATS60]

sometimes oil comes out after an injection...i usually shoot with a 27g 1/2" or 25g 5/8" in small groups (delts, biceps, triceps)...too small pins?

Well thats because you pins aren't long enough, i'm suprised you haven't had any other problems, you just been lucky so far, get some 23g 1 1/4 blues or similiar but NEVER shoot gear with a pin less than 1 inch long.
Next time pal, do some research and stay healthy.

[The Deuce]

Well thats because you pins aren't long enough, i'm suprised you haven't had any other problems, you just been lucky so far, get some 23g 1 1/4 blues or similiar but NEVER shoot gear with a pin less than 1 inch long.
Next time pal, do some research and stay healthy.

Ummm I am not sure I like that advice brotha....

5/8" is GREAT for Delts I think

and 1/2" is almost optimum for shootin' bicep and tricep... I sometimes go for 5/8" when doing those too... but to each their own..

I THINK 1 1/4 " IS TOO MUCH FOR EITHER INJECTION LISTED ABOVE... JMHO

No harm no foul... I just personally don't believe yah... and we all have our own quirks...

[thai-lan]

LATS60 is right never pin with shorter than 1inch needle . I hope spots that you pinned arnt developing abscess...

[johnnybigguns]

Personally I use a 1 inch everywhere except glutes but I don't shoot them.
try leaving the needle in for a good 10 seconds after your shot that may help.
Also you can look up z-tracking

[OzzyBigMan]

Personally I use a 1 inch everywhere except glutes but I don't shoot them.
try leaving the needle in for a good 10 seconds after

This works for me aswell, 1in no glutes leave pin in for 10-15sec

[marcus300]

Try using the Z- track method of injecting and you wont get oil coming out -

http://www.enotes.com/nursing-encycl...rack-injection

[Akrobatik]

You need a longer needle.

[yesimussing]

Also make sure you r relaxed thru the whole process. Also rub the area real good after the injection. If you go in the gluts get a 1 1/2 inch needle. For everything else 1 inch is fine depending on your size and bf.

[johnnybigguns]

I also don't 100% agree that a longer needle were cure this problem.
I have buried a 1.5 in my quads and still had oil leak before

[SuperLift]

the oil leaking as nothing to do with the length of the needle (unless your putting it like 1/4'' in.) Pull your skin to the side, puncture the skin then relax and inject. When you withdraw the needle the hole will be covered. Taught us that in school.

[SuperLift]

Also, 5/8 is to short.. 1'' is optimal in quads, delts. Glutes go for 1.5''

In school they made us use a 1.5 in the delt... kinda spooked me haha

[Dougewesq]

1 inch in delts, push plunger nice and slow, send your juice to its home, he has his bags packed, his airline ticket, send him home he's not to good for his home.

[DS21]

I agree with keeping it in for 10+ seconds after injection.

[tinytom777]

well i'm on my third cycle, 1st cycle did primarily my glues with greens, then moved onto chest, shoulders, bi's and lats lats using small orange 16mm 5/8, why should i use anything over this? i mean 1inch into bi's and shoulders!!! would be hitting bone!!!! sure in glutes but not anywhere else just mho!

[Ashop]

sometimes oil comes out after an injection...i usually shoot with a 27g 1/2" or 25g 5/8" in small groups (delts, biceps, triceps)...too small pins?

AAS are meant to be injected deep IM.
1.5" FOR GLUTES and 1" for everything else is what we use.