Having trouble!

[benNV]

Ok when i draw from the vial the oil only trickles down into the syringe and it takes about 10 pulls of the syringe to get 1cc out of the vial! Will this effect anything i'm using a 23g by the way

[redz]

It doesnt matter if it takes a while. It will be fine.

[aestheticmind]

try setting the vial in some warm water for a few minutes before drawing, should make it easier.

[Mooseman33]

screw all that, get urself a 18 gauge pin to load the syringe.
once loaded, take the 18g off and put ur 23g on..

simple as that.

[1bigun11]

screw all that, get urself a 18 gauge pin to load the syringe.
once loaded, take the 18g off and put ur 23g on..

simple as that.

Exactly. Depends on whats available, so for now I have to draw w a 21 and shoot w a 25, but you get idea mate? Quit screwing around and get a smaller ga (= bigger diameter pin)

cheers.

[jfalco]

Are you adding air to the vial before you draw?

[gymnerd]

Are you adding air to the vial before you draw?

This^^^

[benNV]

Yeah i'm adding 3cc of air also! Will a 20g be ok to make it easier!