HCG amp instuctions needed!!!

[edman44]

I have 2 amps of 5000iu hcg, and 2 amps of 1ml solvent. i purchased a cycle and this was one of the chemicals i will be taking. i need to take 500 iu's every 4-5 days. i do not know how to mix this stuff. i have lots of bacteriostatic water, but no sterile vials. are the 1ml amps of solvent the same as bacteriostatic water? can i just get sterile 10 ml vials, fill it with 10ml of bacteriostatic water and put all 5000 ius of the hcg powder in vial. therefore 1 ml of solution would equal 500 iu's. i guess that i would have to mix solvent from 2 amps into powder amps, then transfer to the 10ml vials of bacteriostatic water. is this right? could i just use the bacteriostatic water to put in powder amps? lots of questions here, any help and i would be grateful...

[ScotchGuard02]

If you put 1ml of solvent, I'm assuming it BW, then the concentration is 5000iu/ml. Each 10 on the insulin syringe will be 500iu. If you put 2ml of solvent in the 5000iu vial the concentration is 5000iu/2ml or 2500iu/ml. Then each 10 on the insulin syringe will be 250iu. I just keep the HCG in the HCG amp and not transfer it unless you want to. There's really no need to transfer it.

[stevey_6t9]

throw away the solvent, im guessing its 0.9% sodium chloride?

NaCl isnt bacteriostatic unless BA is added. Check the back of it to make sure.

though you shoud just go on ar-r and get some bact water and sterile vials and do it properly.