Results 1 to 7 of 7

Thread: Long cutting stack-please advice

  1. #1

    One rip, Var, Primo cutting stack-please advice

    Hey,

    To cut to the chase I'm about ready for what will be my 6 course. Age 29, 5'10, 200lb, not sure body fat it's not to high. Anyway I havnt been on since last September due to a nasty bicep tear. I've been stocking up my gear. With what I have I was going to run the course below. I don't like being to bulky just cut an hard. Any thoughts or ammendments are welcome.

    Week 1-8
    1.5ml One Rip EOD (tren,test,mast blend)
    100mg Oral anovar ED

    Bridge with 2ml Primo EOD for 6 weeks

    Final phase would be 6-8 weeks Test/Masteron 1ml each EOD whilst running oral clen on the side 140mg a day 2 weeks on 2 off which will run beyond the test/mast.


    Quite long I know but the primo is light in the middle. I have PCT at the ready obviously.
    Last edited by CocoBeware; 03-28-2012 at 03:43 AM.

  2. #2
    Bump

  3. #3
    Last bump!

  4. #4
    Why the two separate cycles with a Primo bridge? I would think your first 8 week cycle with good diet should reduce quite a bit of fat. You could run the clen in the cycle. I have to admit I'm not into long cycles. It think it's too hard to recover. Especially when the cycle you're running is some strong stuff and you're so young.

  5. #5
    Thanks for you reply. I know your right I'm just annoyed at my lay off so wanted to hammer it! Agreed though, decided to run one rip and anavar for 10 weeks will shoot my other gear late in the year.

    Start Monday

  6. #6
    Join Date
    May 2006
    Location
    sydney, australia
    Posts
    3,512
    post the diet mate

  7. #7
    Join Date
    Sep 2006
    Location
    socal
    Posts
    545
    could you break out the actual mg/week for your two cycles?

    atleast from what i think i read you are going to run more mg/week the first round then the second. then the second round add in clen?

    why not just run a 12-16 week test/tren/mast until you get the leanness you are looking for?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •