Pinned Quad but leaked out?

[garryjohn89]

Ok im pinning 2 times a week so alternate from left to right legs each time... Never had an issue until now
I use 23g for injecting,
Yesterday as per normal i went about my injection but injected my test enanthate a little bit faster than usual still the normal depth (1inch) in the middle of my quad an inch to the outer side as i pulled the needle out it was instantly followed by one to two drops of test that ran down my leg bit devastating that it didn't stay in my muscle lol
Has anyone ever had this and is it just because i went about it a little too fast??

"lift eat sleep & repeat..."

[castiron]

once ur done pushing in the plunger leave the needle in there for about 10 seconds, this allows the juice to settle a bit and should prevent this.

[garryjohn89]

Ah ok thanks for the advice mate, definitely be doing that from now then almost sad knowing that those two or so drops were wasted lol

"lift eat sleep & repeat..."

[ScotchGuard02]

I've never that that problem but I take my time injecting. About 45 to 60sec per cc.

[Nuzzi]

as said above, leave it in for a few, maybe try 25g also, less waste plus a smaller hole. gotta be patient when injecting

[BlueWaffle21]

Try the whole pulling the skin method before you inject, supposedly when you pull the needle out the hole isn't perfectly straight and it's tough to leak out!!

[austinite]

It happens to me if I pin post workout for some reason. But anyway, pin slowly. I do 1 minute per ML. You could also leave the pin in for 20 seconds to allow time for absorption. Cover the spot instantly after pulling the pin, which needs to be pulled quickly.

It's not uncommon for the juice to follow the pin on the way out. I wouldnt worry about the 2 drops. You'll be fine.

[BlueWaffle21]

This is what I was talking about!!!

http://forums.steroid.com/showthread...ack-injections...

[garryjohn89]

Awesome replys guys the z track method sounds good ill give it a shot thanks

"lift eat sleep & repeat..."