Test E 400 pining

[gatorfan1026]

This is for research, just looking for some information, thinking about doing my first cycle ever and want to be fully informed on as much as I can before I make the leap. From what Iv seen your first cycle should be a test only cycle. I was thinking about running test E 400 weeks 1-12 at 500mg a week split Mon. and Thur. with aromasin 12.5 EOD starting week 3, and pct Clomid 100/100/50/50 Nolva 40/40/20/20. My question is, if using Test E 400 would you pin .75cc twice a week or 2.5cc to get to 500mg's. I was not sure cause of the Test E "400". Any advise would be appreciated.

[Anxnymous]

I'm not following you.. Whats your vial dosage? I'm on tren, its 10ml 100mgs/ml, 1/2cc=100mgs.

[diabolicsoul]

I'm not following you.. Whats your vial dosage? I'm on tren, its 10ml 100mgs/ml, 1/2cc=100mgs.

1 ml = 1 cc

If it's 100mg/ml then 1cc=100mg.

[JohnnyVegas]

You want 250mg per injection.

You have 400mg/ml.

That means you would inject .625ml.

That is because .625 * 400 = 250.

Your example of .75ml would give you 300mg per injection, which is 600mg per week.

[JohnnyVegas]

I'm not following you.. Whats your vial dosage? I'm on tren, its 10ml 100mgs/ml, 1/2cc=100mgs.

Incorrect.

1 ml = 1 cc

If it's 100mg/ml then 1cc=100mg.

Correct.

[gatorfan1026]

Ok I see what Iv been missing, I thought that 1ml =100mg, I see that its saying that each ml contains 400mg, so in order to get 500mg a week I would pin at .75 ml twice a week which would put me at 600mg. Will the extra 100mg make a difference or should I get closer to 500mg?

[JohnnyVegas]

Ok I see what Iv been missing, I thought that 1ml =100mg, I see that its saying that each ml contains 400mg, so in order to get 500mg a week I would pin at .75 ml twice a week which would put me at 600mg. Will the extra 100mg make a difference or should I get closer to 500mg?

All these drugs should have the concentration on the label. It should literally say 100mg/ml (or whatever) on it. If you are taking Test 400, it should have 400mg/ml but definitely read the label so you know exactly what it going on.

500 or 600 are both solid starting doses. You might want to start at 500 and use .625ml. I know there is no hash mark for that, but you will get close enough.

[gatorfan1026]

I understand it now, Thanks for the help.

[Far from massive]

Quick note;

Test of this high a concentration (400 mg/ml) is notorious for causing pain the day after injection as it often forms microcrystals in the muscle. You would be a lot better off doing some Test E dosed at 250 mg/ml particularly since its your first cycle.

Also it would be a good idea to use 250 IU's of HCG twice per week while on cycle (you can wait till week 3 to start if you want) as this will prevent atrophy of the testicles through direct stimulation of the Testes. This will also make recovery of testicular function easier during PCT.

Good luck with the cycle whichever route you choose.