Hello, been training since I was 16, very interested in starting a cycle!
if someone could lead me in the right direction it would be great!
Thanks, also if other aussie members would contact me it would be great!
- Fraser1994
Hello, been training since I was 16, very interested in starting a cycle!
if someone could lead me in the right direction it would be great!
Thanks, also if other aussie members would contact me it would be great!
- Fraser1994
Last edited by Fraser1994; 12-12-2012 at 11:09 AM.
Welcome to the forum.
Almost everybody here will say you are too young to cycle. Read this
http://forums.steroid.com/showthread...t=#post6285955
Please visit the nutrition section for some pointers too.
What are your stats?
Hoping you're not asking other Aussie members to contact you so they can provide you with a supplier, you'll be setting yourself up for getting scammed.
Welcome!
Welcome.
I think a little more reading and research would benefit you, particularly for someone your age. It’s best to know the complications and associated health risks that could affect you should you decide to embark on this journey sooner than later. A few more years to allow your developing endocrine system to finish growing, and then perhaps look at using AAS. Otherwise you could be setting yourself up for a host of unwanted side affects including premature closure of your growth plates, Erectile Dysfunction, Gynecomastia (b*tch t*ts), and more..
Take a look at this link and please read it. I think you will agree that it is both informative and educational.
Cheers and good luck.
The Young and Steroids
http://forums.steroid.com/showthread...s#.ULk5-mfX_fs
Welcome
Welcome
Good luck
Sent from my iPhone using Forum
Welcome. Chef brah?
I live in western australia.
Take it now or wait 5 years i dont really care your going to do what you want anyway. but at least have everything on hand before your first pin. Ai, serms , hcg, enough juice.
You havent even stated what you want to achieve gain mass, cut fat etc.
There are currently 1 users browsing this thread. (0 members and 1 guests)