Debris in my Tren E....should I still use it?

[Shadow530i]

I have some debris (floating...stuff?) in my oil....I've been taking this gear for months now with no issue's...never noticed this before in the vial but cannot say it wasn't there...what is it and what should I do?

[ironbeck]

put it in a pan and heat the vial to160 degrees for 5 min then let cool. You may need to filter it, if that doesnt work.

[Shadow530i]

What is the debris? Do I heat the vial in water or without anything?

[DJMikeT]

What is the debris? Do I heat the vial in water or without anything?

I always heat things up in a water bath for even heating. Use a small pan with water going up about half way to 2/3 of the height of your bottle. Let your water get warm first then put in the bottle as mentioned above for 5 mins and yes I would definitely filter it again. Monitor your water temp with a thermometer. Also put a needle into the vial so it can vent as it warms.

[Shadow530i]

I always heat things up in a water bath for even heating. Use a small pan with water going up about half way to 2/3 of the height of your bottle. Let your water get warm first then put in the bottle as mentioned above for 5 mins and yes I would definitely filter it again. Monitor your water temp with a thermometer. Also put a needle into the vial so it can vent as it warms.

So is the debris just the tren sticking together so to speak? and heating it will fix the problem? I don't have the equipment to filter gear...at least I don't think I do. What does it take?

[michael30]

No heating it steralizes it(i believe) also all you have to do to filter it is go to our site sponser . Top right corner(ar-r) an they sell filters for afew dollars. I would also buy a sterile 10ml bottle. So as you filter it you just put it into your new sterile bottle. * note the filter just goes right on your syringe. When u push out the oil it filters it)

[Red Bastard]

Tren seems to be a difficult compound to keep in suspension, from what i've heard. I've noticed a bit of precipitate, in vials, especially after some usage. If it's not causing discomfort, is it an issue?

Or, could it be bits of rubber stopper, from drawing with a large guage needle? Guys who use 18g, seem to have issues with that...

[< <Samson> >]

I don't know why no one asked

What does this debris look like?

[Iron-56]

If you never realized it before then its probably a piece of rubber from the cap. Happens quite alot and I believe the term for it is coring.