Printable View
I have 10iu Blue Tops. When mixing I use 1cc of BW and add it to the 10iu. I have 1/2 cc 31g pins.
I have been adding the 1cc and then drawing back to the 20 mark. Wouldn't this be 2iu? Am I correct....
I have been getting sore spots at injection sites. I am ordering some new BW water since what i have been using is old. Also was curious if I should add 2cc of BW water to the 10 iu of HGH I have....
Thanks, any help is appreciated...
adding 1cc to 10iu, then drawing to the 20 mark on a slin pin would indeed be 2iu.
as for adding 2cc, I only add 1cc per 10iu.
You are spot on. .2cc would be 2iu. I am also getting some red marks from my blue tops. Make sure you go in at a 45 degree angle. I found if I pinch the skin, stick the needle in and release the pinch before shooting I have less redness. Also shoot it slowly. And of course vary your injection site.
the blues i got are very goood =)
i get the odd bit off soreness, but i thought it would be standard off pins, no biggy
sorry to be dumb
1 cc is 1ml i presume?
1cc is 1ml. if you want to add 2cc's of water then the 40 mark would be 2ius and so on. i use 2cc's now per 10iu vial to help dilute the hgh moreso i dont lose as much if i dont get every drop or some comes out
when using hgh a 1cc syringe is always easier and your best bet. each 1cc syringe has 100 clicks on it and to determine the amount of hgh your using with 1ml of water you take the total number of clicks and divide it by the number of ius per vial. example. you have a 10iu vial and you add 1ml of water so 100clicks divided by 10iu vial is 10, so 10 clicks is 1iu