trouble drawing nolva out of bottle

[WonderMikeJ]

i'm using Liquifen from Pnp - and i have to draw it out of course with one of my pins..

the problem is , it takes like ten minutes.. i've heated, shook it .. everything aside from buying pins..

any suggestions and making it flow better..

i'm using test prop and it makes that stuff look like water coming out in comparison.. and thats some thick stuff

[956Vette]

what gauge needle are you using?

[johnsomebody]

Do you inject air into it first? You should do that with any vial you intend to draw from.

If you haven't been doing that, before you go into the vial, pull some air equivalent to the amount you intend to pull out into the syringe, then blow it into the vial after you've entered it with the pin. Then invert and pull the fluid.

You may have a vacuum there already from forcing fluid out without replacing it with air, so you might want to add extra.

[WonderMikeJ]

good call i'll try that..

appreciate it..

[cyberthug66]

Why use the needle....take it off and just use the syringe.

[WonderMikeJ]

take off the metal cap with the rubber stabbing surface ?

won't that kill any sterility and possibly cause it to go sour and lose effectiveness?

[Pale Horse]

nolva in a glass sterile vial? weird.

[956Vette]

no, dont take the cap off. orals dont need to be sterile...and arent. What is the issuse here?

[Matrix78]

Why use the needle....take it off and just use the syringe.

i got some Nolva from PNP before and thats what i did, jsut take the top off its not like it needs to be sterile it's going in your mouth not ur muscle

[Pale Horse]

I have never seen an oral in a sealed sterile vial. It is too thick & or grainy to draw out w/a needle the cap has to come off. Sterility is not an issue here.

[WonderMikeJ]

understood about sterility... just wanted to be sure..

luck is for the ill prepared.