Does anyone know if it will hurt my gear if a place the vials in hot water for a few minutes before using? It makes it easier to get throught the thin needles and is less painful to inject when its warm.
New Member
Does anyone know if it will hurt my gear if a place the vials in hot water for a few minutes before using? It makes it easier to get throught the thin needles and is less painful to inject when its warm.
Knowledgeable Member
No it will not hurt the gear. I have done this with winny to help make it not get stuck as much in the pins. I think alot of people do this and it shouldnt cause any problems.
Member
I almost always heat my vials in water if not anything it makes drawing easier. And definetly helps with painful injects like prop and win
Associate Member
you can also use a blow dryer to heat it up
Senior Member
??Originally Posted by logen32
haah wayy to much work , i put my vial in a sandwich bag and drop it in a cup of warm water, just above body temp. so by the time you got your needle loaded it will be good to go
Junior Member
I just roll it in my hands for a minute or two and it stays warm enough to aid in drawing and injecting!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote