Update and question on winstrol

[Foo2011]

http://forums.steroid.com/showthread...ight=2nd+cycle

Hey guys, just here to post an update and have one small question... The link above is a thread i posted about 3-4 weeks ago before i started my cycle. My cycles goin awsome and its still very early, i increased all my weights, my strength is way up there. I'm already weighing in at 210 212ish with a lower bf %. My only question is i'm bulking up and everything but i have some winstrol i wanna start taking when i'm done with this cycle to cut up and get ready for summer. I was wondering how long i should wait after my PCT to start something like that?

[T-MOS]

read the other thread

what exactly did you end up running and how long are you running it for

I would NOT end a cycle and start winny by itself if that is what you meant

general rule for time off is length of cycle PLUS your pct time= time off

[Foo2011]

i'm runnin sust for weeks 1-12 @ 500mg, deca for weeks 1-10 @ 500mg, dbol for weeks 1-4 @ 40mg...would if i ran the winstrol at the end of my cycle? say for the last 4 weeks....?

[T-MOS]

i'm runnin sust for weeks 1-12 @ 500mg, deca for weeks 1-10 @ 500mg, dbol for weeks 1-4 @ 40mg...would if i ran the winstrol at the end of my cycle? say for the last 4 weeks....?

you could do that if you wanted. You will only notice anything from it if your bodyfat is already low, and by the look of your other thread, you were trying to bulk up so I am guessing you gained or will gain a little bodyfat.

anyway, PCT timing for sust is 18 days after your last injection, and PCT timing for winny is the day after your last dose, so time it so that the winny lasts you 18 days after your last sust shot then start your pct the day after last winny dose

[Foo2011]

Okay, i'll time everything to work out. How about dosages for winny? how much should i take for lets say the 2nd half of my cycle?

[bmit]

I only had success with winny when i was under 10% body fat. Tried using it to finish out a bulking cycle you propose - didn't do jack. save it for your cutter cycle