does the depot hurt more the higher the mg/ml that you inject? I'm pinning 1cc 300mg/ml cyp 2x wk.
does the depot hurt more the higher the mg/ml that you inject? I'm pinning 1cc 300mg/ml cyp 2x wk.
This is often a problem, lots of time the pain at an injection site is the result of the other ingredients being absorbed before the steroid, this causes the steroid to crash in the muscle and as a general rule the higher the concentration the more likely the problem is to occur. In addition to this the higher the melting point of the steroid in degrees the more likely this is to occur as low melting point steroids do not need nearly as much cosolvents to stay in solution with Test E for example oil alone will hold it in solution at common concentrations. Cyp is not quite as friendly and 200-250 is a much better range for painless injections with common solvents BA/BB/Oil if you don't mind adding EO or another more aggressive solvent to the mix then higher concentration can be achieved with relatively painfree results.
My guess is that this gear is dosed at 300mg/ml with only BA/BB/oil as the other ingredients. If the site is not showing any signs of infection, Hot, Swollen,Sensitive to touch, etc You might try placing a heat pad on the site for 5 minutes every 15 minutes for an hour or two an evening till it subsides. This will help absorption.
FFM
Last edited by Far from massive; 01-20-2011 at 04:06 PM.
Also let me guess the injection is at the thigh muscle? It may be less likely to present a problem in the glutes, I don't know why my thought would be that absorption is slower in the glute lessening the separation of the components all I know is for me high mg gear seemed to be less painful in the glute than the thigh.
I am running 500mg of test P and so i would do 1.4ml 3 times a week and i originally did it in my glute but i had too much scar tissue so i now do it in my delts and the pain is the same at the start but it just lasts longer in the delt.
Yeah it is 300mg/ml cyp and I'm injecting in the glute and have done one in the delt and have had the same soreness for like 3 days after but not real bad.
for me personally, (ive only injected 4 times)
i found glutes to be painful for up to 8days.
whereas quads were completely pain free, and i was able to do it myself.
kinda wish i used prop now i realize how easy the pins actually are..
If you don't want to put the full amount into a single injection site, you can pin two sites
I don't do too much so it's never really been an issue for me
just make sure you keep everything sterile
iv read that if your warm it slightly it helps your bod absorb it easier... and of corse masarge the area for a while
Might try warming the gear a bit before the injection to see how that works. The pain isn't real severe but its annoying.
There are currently 1 users browsing this thread. (0 members and 1 guests)