HELP, crystallized Test E

[Meanlock]

Im 6-7 weeks into my test and deca cycle. Good gains and everything has been fine so far. When i reached by 6th week i had to pop a new Test E vial since the last one was empty. I noticed a few crystals in it, nothing overwhelming, so I took the shot anyways with no pain or nothing. In 2 days im about to pin myself again. I took a look at the exact same vial, only to notice that the crystals had grown and the liquid had decreased alot. Out of the 3 test vials im running in total, this was the only one with crystals in it.

Now, am I supposted to put it in some hot water with a pin in it and let it rest for a little, to desolve the crystals? And is it normal for a sudden growth in crystals? It honestly scared me a bit, but the gear itself is great. Have been in contact with my supplier who just told me to heat it up.

[swolehead]

not sure on the specifics but yes needle in top to release the pressure and put it in warm water

[Bonaparte]

It isn't Test E. (Probably cyp)
But yeah, just heat it up to increase the solute's solubility. And no need to vent it.

[Meanlock]

It isn't Test E. (Probably cyp)
But yeah, just heat it up to increase the solute's solubility. And no need to vent it.

Im positive that it's Test E. I scanned the code on the pack and had it confirmed on their homepage

Edit: Also, the vial is VERY crystallized. I believe its about 1:4 Liquid:crystals

[Bonaparte]

Lol, what?
Test E doesn't crash, as it is soluble in oil and 1% BA at 300+mg/ml. You're not keeping it in your freezer, are you?

[lovbyts]

Im positive that it's Test E. I scanned the code on the pack and had it confirmed on their homepage

Edit: Also, the vial is VERY crystallized. I believe its about 1:4 Liquid:crystals

Scan is meaningless unless it's from a pharmacy. I'm sure Bonaparte is correct and they made it using Test C powder. Most people would never know the difference unless like this where it crashed.

As said just heat it up and I agree, No to the vent. You are only allowing contaminants to get into the vial. You wont increase the pressure enough to make a difference unless the vial is so full you dont have any space between the liquid and the cap.

[Meanlock]

Lol, what?
Test E doesn't crash, as it is soluble in oil and 1% BA at 300+mg/ml. You're not keeping it in your freezer, are you?

Thanks for the replies
But to my understanding, Test E can also crash if its too strong / not enough BA/BB oil? Or am i mistaken? Would love to hear some input before I inject it into myself hehe..

[Deal Me In]

What is the concentration of the test?

[Bonaparte]

Thanks for the replies
But to my understanding, Test E can also crash if its too strong / not enough BA/BB oil? Or am i mistaken? Would love to hear some input before I inject it into myself hehe..

Again, it is possible for it to crash, but it would have to be over 300mg/ml and not contain any solvents.

[tdoe11]

The only gear I have seen crash is a couple Watson cyp bottles. Bastards.....all the sketchy ugl stuff was always fine. Hah go figure.

[lovbyts]

It doesn't matter if you believe it's test E or C just heat it up so the crystals melt and it goes back into solution.