possible to draw Winny Depot from 20 amps and inject into a new sealed 20ml vial ?

[kamchez]

Hey ... topic says it all ...

I have lots of winny Depot amps from zambon , What I was thinking was ...Its easier and more convienient to have 1 "big" vial , 20ml of gear instead of 10-20 1ml amps laying around ...

so ..is it possible ? ..since winny is water based.....and it will get separated if laying around ...and when I finally want to use it ... maybe It wont be 50mg/ml whenever I want to draw new gear into the syringe because of the separation ?.

any inputs ?

[kamchez]

buump buump !!

[GREENMACHINE]

Why would you want to bother. You are increasing the risk for infection?

[kamchez]

well ...it seems more convienient to have a 20ml vial ...than 20 x 1ml amps ... besides... Im curious 2 know whether its possible to get an even amount (50mg/1ml) with winny ...since its waterbased ..and the stanozol gets separated from the water....

[G-1000]

i dont think i would do that. there is no way to keep it steril

[The Baron]

Bear in mind that you cannot filter it, because it is a suspension.

Assumingn your amps are 1ml at 50mg/ml and you intend to run 50mg/ED, no reason to do this. If your dose needs to be one that does not neatly divide into 50mg then maybe transfering the gear has some merit, but you don't have to do the whole lot at once.

At any rate, don't worry about separation. Just shake well, whether it is an amp or a vial, before drawing your shot.


--
NO PMs for SOURCES!
NO PMs for questions that should be asked on the board!
NO "Thank You" PMs, please.
PMs are for personal or sensitive questions or information, or for stuff that is not allowed to be posted on the board.
Inappropriate PMs will not be read or acknowledged. Repeat offenders will be reported.
-The Baron-