Results 1 to 7 of 7

Thread: very hard to push in the pin

  1. #1
    Join Date
    Feb 2005
    Location
    Your little sister
    Posts
    1,129

    very hard to push in the pin

    so I tried to inject my delt just now. last hit it on tuesday. I put the pin to the spot and push. I feel it break the skin and then that's it. I can't push anymore. not just hard to push, it just won't go. my delt depressed about half an inch from the pressure but no dice on going through the muscle. now I know its not infected. its not hard to the touch (no more than anybody else on juice), its not warm, its not red. feels totally fine just can't go through it. the inject on tue by the way was easy as pie. does scar tissue just pop up like that? the shot on tue was also big. 2.4 cc's. done it plenty if times

  2. #2
    Join Date
    Jul 2006
    Posts
    1,446
    Dont put it to your skin and push, pull back and jab. You should be sticking in one fluid motion. You should be holding it much like a dart, in your finger tips. Aim, pull back, stick. After that you should only have to adjust a little.

    You will get scar tissue built up if you have injected yourself a lot there. The switch fluid motion will get you through the scar tissue with a breeze and without the mental block telling you to go easy.

  3. #3
    Join Date
    Dec 2006
    Location
    Between mrs.misery's legs
    Posts
    5,091
    I had the same problem until I started to switch injection sites everytime.

  4. #4
    Join Date
    Aug 2005
    Location
    CANADA
    Posts
    854
    you can inject in 1 fluid motion, or push in slowly whichever you prefer, scar tissue is the factor here. Rotate sites bruh. merry xmas

  5. #5
    Join Date
    Aug 2005
    Location
    CANADA
    Posts
    854
    i jab to break the skin, the push the rest in. works good for me.

  6. #6
    Join Date
    Apr 2006
    Location
    orlando.fl
    Posts
    393
    once you stick the pin through the rubber stopper the pin becomes dull.. if the pin touches the bottom the vile this will also cause it to become dull aswell. after putting it through the rubber stopper swithch out the pin and see if this will make the pin go in in one motion..

    all this is explain on the injection site.. i guess nobody stops to read the entire page. people just look at the pictures and see where is it at to inject and proceed..

  7. #7
    Join Date
    Dec 2004
    Location
    uk
    Posts
    7,979
    do you rotate sites? If not, start.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •