Having problems with injections, any advice?

[Jnsa]

I'm having problems getting the gear out of the needle. I try for the injection but the liquid will not come out, and this is with me not putting too much force behind it, but I know I shouldn't have to. I'm using the correct size needles and I'm checking before I inject and it's coming out before hand. After it's in I gentley pull back and everything is fine so then I try to push and it will not go... I take it out and and still very hard to push, it looks like tissue has clogged the needle. Never had this problem and already tried two different types of needles??? Any advice???

[scotty51312]

What are you injecting? What gauge needle? Are you warming up the gear before injecting?

[Jnsa]

Wini Stan 50\ 21 1.5in

[Jnsa]

Haven't tried warming up the gear. You recommend it?

[scotty51312]

Not sure its going to help. I've read a lot about people having the same issue with injectable winny. 21gauge is pretty large. I suppose you could try injecting it subcutanous and see if you have the same problem. If worse comes to worse you can always drink the winny won't be as potent and will stress your liver more but you can always run some liver support after.

[Jnsa]

Ment 22, thx for the advice.

[Bonaparte]

Its because you're using a water-based suspension, so the hormone crystals are clogging up the needle.
You need to heat that stuff up real hot, shake well, then draw and inject as quickly as possible before it has time to cool and clog up the needle again. + if your gear can clog a 21g, it wasn't well made.

[Jnsa]

What's the best way to heat it?

[MACHINE5150]

put the bottle of gear in hot water

[redz]

Winny is a pain to inject, I had the same problem even with 21G pins. Some winny just wont go through smoothly. It is also brutally painful after injection.

[Bonaparte]

What's the best way to heat it?

Just heat a glass of water in the microwave for a minute or two (till it is steaming), then sit the vial in there while you're prepping for your injection.