Results 1 to 4 of 4

Thread: First Tren Cycle (blast)

  1. #1

    First Tren Cycle (blast)

    37yrs old
    First cycle was 500mg test-e for 12 weeks + 6 weeks of anavar in fall 2024. Overused aromasin (25mg ed) but other than that the cycle went fine.
    Been lifting for 20+ years.
    Started hrt about 4 weeks ago
    -200 test-c ew
    -200 deca ew
    -2iu HGH ed (ugl)
    -10mg cialis ed(ugl)

    Diet is dialed in 200-240g protein, 200-300g carbs, <70g fats (eggs, egg whites, chicken breast, ground turkey, white rice, spinach, broccoli, oatmeal blueberries, etc). Daily supplements: tudca, multivitamin, fish oil, glutamine, creatine, collagens, ECAAs, NAC, Tyrosine, Olive leaf, etc
    5’8”
    11.2% bf (via bod pod scan)
    Current weight 192lb dry


    I know its a jump to go to tren so soon, but my goals are short 6-8 week blasts and 4-8 week cruises. Trying to keep oil volume low, best bang for my buck, low sides and hard lean gains.

    Here is what I had in mind, to just dip my toes in the tren first go around...essentially just adding tren to my hrt protocol.

    Wk 1-8 50mg tren-a eod
    Wk 1-8 200mg test-c
    Wk 1-8 400mg mast p
    Wk 1-8 200mg deca
    Wk 1-8 2iu HGH ed

    I have plenty caber, nolva and aromasin on hand, just in case.

    1.) Would yall recommend removing the mast and just supplementing .5mg caber e3d instead?
    2.) Should I remove the second 19 nor compound (deca) during my cycle?
    3.) Can I just do the tren/mast 3x per week instead of e3d and can I put both of these in the same syringe? Mast oil contains 2% Benzyl Alcohol, Tren oil contains 2% Benzyl Alcohol & 12% Benzyl Benzoate. How do you know what compounds can be mixed in same syringe?
    4.) I’d like to avoid losing hair as much as possible and I know the mast is a dht derivative so high chance there. What is the minimum effective dosage of mast? I’m willing to try and just drop it if I notice my hair doesn’t react well. Only had bit of thinning with 70mg ed of anavar for 6 weeks in last cycle.

    Im thinking removing the mast and just adding the tren and caber for first time. Then maybe adding mast next time to keep things more simple and controlled.
    Last edited by BrotherTheresa; 01-07-2025 at 08:09 AM.

  2. #2
    Join Date
    Nov 2007
    Location
    GTA
    Posts
    14,259
    Don’t run caber ever unless you need to. Less is more always. Ironically if estrogen isn’t jacked up you likely will never have prolactin issues.

  3. #3
    I?d double-check your sources for legit gear and PCT stuff?super easy to mess that up and feel like trash halfway through. I personally had a much better experience once I ordered from asteralabs.org. Not saying it fixes everything, but quality made a big difference for me, especially with something as strong as Tren. Also, don?t skip out on support like Caber if you?re prone to prolactin sides.
    Last edited by JaceReese; 04-14-2025 at 02:34 AM.

  4. #4
    When i was on blasting and cruising, I used to sitting down, figure out all my compound (test, mast, primo) And id figure out how much of each i needed, mix sll 3 into a 15ml empty vial, that would be My blast mix.

    Helped that my source had exteme high concentration gear that stayed in solution, didn't crash and was not underdosed. Thier test e 500 came in consistently at 515-540mg per ml. It made mixes much More efficient and could get away with a single 3ml barrel and usually a single shot.

    If you list all your desired drugs, concentration, i could give you a mix recipe with dosing info.

    When i cruised (trt) i would also Make a eod mix. I used to pin test e mix eod, blood's on it came back perfect. Test at 916ng/dl, estrogen Dead smack in 5he middle, slightly elevated bad cholesterol, but was expected.

    Id used a small dose mast e for ai. As mast will blunt low level aromatization. I think i was on 62.5mg test eod with 7mg mast and 7mg primo per shot.

    Gave me 218mg test, and 24.5mg each primo And mast
    Last edited by Cchlckd; 04-13-2025 at 10:14 AM.

Thread Information

Users Browsing this Thread

There are currently 3 users browsing this thread. (0 members and 3 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •