Is this a common thing to see in vials of Tren A? If I shake it hard, it goes away but the solution looks so cloudy and thick.
Printable View
Is this a common thing to see in vials of Tren A? If I shake it hard, it goes away but the solution looks so cloudy and thick.
mine is the same way, it wasn't when i first made it. I was tempted to filter it a second time, but based on others experience I just went ahead and started using it. No pain or anything, I just shake it up really well before using so it distributes evenly.
Possible water contamination?
warm it back up in a water bath, and most likely, this will go away
Mines the same. I warmed it several times and it's only a quick temporary fix. I also tried drawing off any potential water vapour between the tren and the rubber stopper in case there was water trapped (not sure that's even likely) but to no avail. Pinning it anyway.
Too funny
I was just gonna start another thread on this. U have a few vials a guy brewed up for that look just like that. Milky at the bottom, gets milky traces through the oil when you move the vial around. Then after moving it around for a bit all if it mixes in.
I haven't ran it yet, since I have more crystal clear vials of TA.
From what I have heard somewhere, can't remember where - it is the plastic from the filter that was dissolved when first being filtered. At least that's what I heard.