Problem adding water to the GH

[symmetry101]

I am taking Jin HGH, I am having problems adding the water to the gh powder. When I stick the needle in the little bottle the water shoots out. I have it pointed to the side but a burst of water hits hard and I wanna get it to gently go onto the side. I hold the plunger still and it doesn't move as I stick it in. Someone with experience have any tricks I can use???

[Deal Me In]

Either vent the vial or add some air to it before you inject. I usually add about .75ml to the vial. Then you won't have any problem.

[toolman]

inject at an angle so the stream hits the side of the vial.

[Ufa]

That air thing is a good idea for later on as well. You could put that water in
with a little bigger needle. maybe a 27gu.

[gypsy3034]

i inject it with a bigger needle but i make sure i hold the stoper with my two fingers and thump so i can releas it slowly and make sure it trickls down the side of the vial.

[vanilla-gorilla]

I can't believe I am reading this. I have the same problem as well. My question is, is my gh worthless after the water just splashes in? God, I hope not.

[Big Bapper]

i inject it with a bigger needle but i make sure i hold the stoper with my two fingers and thump so i can releas it slowly and make sure it trickls down the side of the vial.

Thats the way I do it, only with a smaller pin.

[Big Bapper]

I can't believe I am reading this. I have the same problem as well. My question is, is my gh worthless after the water just splashes in? God, I hope not.

I have seen people just shoot direct into the powder, shake the vial and it still claims it works for them. But would not use that protocal myself. I would go with the method in above post.

[justtrnd40]

simply take a needle off a syringe and stick it into the powder vial. That will release the air pressure, then inject your ba water slowly down the side. Also helps to reduce foaming and bubbles.

[rodge]

i inject it with a bigger needle but i make sure i hold the stoper with my two fingers and thump so i can releas it slowly and make sure it trickls down the side of the vial.

this is how i do it too.

-rodge

[lzicc]

I made that mistake today. I usually vent the powder with a needle first and forgot to do that tonight. I pushed the water filled syringe into the powder vial and it sucked it right in.