glute injections with needles larger than 1.5 inches

[Tbone1975]

Hi there. I've been doing glute injections for quite a while with 20 and 22 gauge inch and a half needles. My friend just shipped me 50 one inch 22 g needles along with 50 I don't know wtf size you want to call it needles. The big ones are only 22 gauge though. So, today, I withdrew my roids from the bottle with the 1 inch, then replaced it with the big one. I kept staring at the needle as I had a bit of a bad feeling. I stuck it in my right glute and pushed, pushed, pushed that fn' thing in there. As I was nearing the end it just stopped like it didn't want to go any further and hurt a bit. So, I stopped there and pulled back on the plunger. One, two, three seconds, finally after about 4 or 5 seconds, blood started to enter the syringe. I pulled it out swearing to myself, hooked on the 1 incher and shot it in my glute. Honestly the needle I first used to inject with is pretty fn' big. It's bigger than my old 1 and a half inchers, and may even be approaching 1.75 inches. I have a couple of questions. First, is there any danger with using a large needle to inject with? That is, a needle that is larger than 1.5 inches. You know what I mean? Like, what would happen if you injected with a 2 inch needle? I just wanna know wtf I hit. But, like I said, these babies are definately under 1.75 inches. Yeah, so it kinda psyched me out so I went to the 1 inchers. Are 1 inch needles too small for a glute injection? If so, why? Do you risk losing your gear? Thanks for reading. Man, I'd appreciate any help I can get. Later.

[joeben22]

1" doesn't get as deep into the muslce in the glutes as you should. If you the larger ones you have are to painful and long then just use the 1" that you have and inject in the delts, and quads. I wouldn't have been using a 20g (ouch!) or 22g previously, you could have used 23g 1 1/2" for the glutes and been fine.

[MotorBoatin' SOB]

23g 1 1/2' is PERFECT for glutes.

[MAXIMA5]

23g 1 1/2' is PERFECT for glutes.

Agreed.
You're asking for trouble using anything longer or thicker than this, especially if you have no idea what the exact specs are.

[Warrior]

It's bigger than my old 1 and a half inchers, and may even be approaching 1.75 inches.

I don't believe I have ever seen a 1.75 inch pin dude... ever... that is quite long...

[MAXIMA5]

Is it possible they are Vet needles for large animals?

[LatinoPR]

Hi there. I've been doing glute injections for quite a while with 20 and 22 gauge inch and a half needles. My friend just shipped me 50 one inch 22 g needles along with 50 I don't know wtf size you want to call it needles. The big ones are only 22 gauge though. So, today, I withdrew my roids from the bottle with the 1 inch, then replaced it with the big one. I kept staring at the needle as I had a bit of a bad feeling. I stuck it in my right glute and pushed, pushed, pushed that fn' thing in there. As I was nearing the end it just stopped like it didn't want to go any further and hurt a bit. So, I stopped there and pulled back on the plunger. One, two, three seconds, finally after about 4 or 5 seconds, blood started to enter the syringe. I pulled it out swearing to myself, hooked on the 1 incher and shot it in my glute. Honestly the needle I first used to inject with is pretty fn' big. It's bigger than my old 1 and a half inchers, and may even be approaching 1.75 inches. I have a couple of questions. First, is there any danger with using a large needle to inject with? That is, a needle that is larger than 1.5 inches. You know what I mean? Like, what would happen if you injected with a 2 inch needle? I just wanna know wtf I hit. But, like I said, these babies are definately under 1.75 inches. Yeah, so it kinda psyched me out so I went to the 1 inchers. Are 1 inch needles too small for a glute injection? If so, why? Do you risk losing your gear? Thanks for reading. Man, I'd appreciate any help I can get. Later.

Here is what you need...1 or 1 1/2" of 21 or 22g or even 23g for youre a$$...thats it...!

[MAXIMA5]

21 or 22 is too big IMO. I don't like using anything that resembles an ice pick.

23 or higher

[ascendant]

21 or 22 is too big IMO. I don't like using anything that resembles an ice pick.

23 or higher

i agree. the larger the needle, the larger the scar tissue left behind from it as well, which is why i always stick with 23 n up. that scar tissue will add up in the long run.

the generally accepted lengths for needles is 1" for quads n delts, and 1 1/2" for glutes. this measurement for these areas allows the needle to go deep enough into the muscle tissue for proper absorption, but not so deep that you are gonna hit a bad spot.

personally i wouldn't suggest going deeper than these measurements, and it's also not necessary. going much deeper than this will most likely not make much of a difference, at least not a positive one as you found out the hard way.

however, make sure to go those depths on each unless you want to risk not hitting deep muscle tissue and not having proper absorption of whatever you're injecting. 5/8" may be ok for quads/delts and some use them, but it's not something i'd suggest personally.

[Tbone1975]

Hopefully I post this right. Just wanted to say thanx everyone. Guess things seem pretty cut and dry now. You know what joeben22, those fn' 20 guage pins did hurt a bit, lol, especially when sitting down the day after. And Warrior, swear to God lol, those big pins are around 1.75 inches. They're from Germany. Well cool. Man, I don't even wanna look at those big pins so I guess for now I'll shoot the 1 inchers in my quad. Thanks again. ttyl

[Ih8urdsm]

Is it possible they are Vet needles for large animals?

...yea, Ronnie Coleman probrobly uses them to inject his pecs

[MAXIMA5]

Hopefully I post this right. Just wanted to say thanx everyone. Guess things seem pretty cut and dry now. You know what joeben22, those fn' 20 guage pins did hurt a bit, lol, especially when sitting down the day after. And Warrior, swear to God lol, those big pins are around 1.75 inches. They're from Germany. Well cool. Man, I don't even wanna look at those big pins so I guess for now I'll shoot the 1 inchers in my quad. Thanks again. ttyl

Hey, I have a 10" steel meat thermometer that would be perfect for a delt injection.

JK

[Swifto]

23g 1 1/2' is PERFECT for glutes.

I use 23G 1.25". Works well.

[mr. snakes]

Hi there. I've been doing glute injections for quite a while with 20 and 22 gauge inch and a half needles. My friend just shipped me 50 one inch 22 g needles along with 50 I don't know wtf size you want to call it needles. The big ones are only 22 gauge though. So, today, I withdrew my roids from the bottle with the 1 inch, then replaced it with the big one. I kept staring at the needle as I had a bit of a bad feeling. I stuck it in my right glute and pushed, pushed, pushed that fn' thing in there. As I was nearing the end it just stopped like it didn't want to go any further and hurt a bit. So, I stopped there and pulled back on the plunger. One, two, three seconds, finally after about 4 or 5 seconds, blood started to enter the syringe. I pulled it out swearing to myself, hooked on the 1 incher and shot it in my glute. Honestly the needle I first used to inject with is pretty fn' big. It's bigger than my old 1 and a half inchers, and may even be approaching 1.75 inches. I have a couple of questions. First, is there any danger with using a large needle to inject with? That is, a needle that is larger than 1.5 inches. You know what I mean? Like, what would happen if you injected with a 2 inch needle? I just wanna know wtf I hit. But, like I said, these babies are definately under 1.75 inches. Yeah, so it kinda psyched me out so I went to the 1 inchers. Are 1 inch needles too small for a glute injection? If so, why? Do you risk losing your gear? Thanks for reading. Man, I'd appreciate any help I can get. Later.

Glutes 23g X 1.5"