Did I heat em too much ?

[guest589745]

I just re heated my masteron, test prop and npp on between low/warm on my stove and I forgot about em !!

They were pretty hot but you guys think they got too hot?

Im kinda worried...........

[tj979]

Dam kid, that sucks haha I never go any hotter than what i can get out of the tap, im fairly new to this (aas) and I would assume that by heating any compound it would change the molecular structure, I COULD BE WRONG, but thats just my opinion, see if you can pm a mod

[brass-man]

depends. can you boil water on that setting? if so.. i have some bad news for you.

[spywizard]

I just re heated my masteron, test prop and npp on between low/warm on my stove and I forgot about em !!

They were pretty hot but you guys think they got too hot?

Im kinda worried...........

did you boil off all the water?? probably not.. so it should be ok..

send it to me, i'll let ya know how it comes out.. u knew this was coming

[tj979]

did you boil off all the water?? probably not.. so it should be ok..

send it to me, i'll let ya know how it comes out..

HAHA

[brass-man]

I was referring to the fact that steroids become molecularly unstable at roughly the same temperature as water boils. They denature/oxidize/hydrolyze at temperatures between 130c and 200C varying by compound. If his stove on that setting is hot enough to boil water, it's likely much hotter than that, maybe hot enough to do some damage.

[spywizard]

I was referring to the fact that steroids become molecularly unstable at roughly the same temperature as water boils. They denature/oxidize/hydrolyze at temperatures between 130c and 200C varying by compound. If his stove on that setting is hot enough to boil water, it's likely much hotter than that, maybe hot enough to do some damage.

i know, you gave solid advice.. good job, and by the by, welcome to ar..

[brass-man]

thanks.

[guest589745]

there was bubbles forming on the bottom of the pan but not really boiling.

[brass-man]

should be fine.