Someone help me out please!!

[joeyaaronson83]

Hey, I'm new to the site, just got a quick question, might be considered a stupid question. But here goes, everywhere that I read about injecting says that you should get the air bubbles out, and then when you inject it, it says to pull back on the plunger anyways to check for blood. Wouldn't that make an air bubble and defeat the whole purpose? So should I not pull back once it's in me or what? I'm kinda confused and I want to make sure I'm doin everything right. Thanks, any help would be great.

[kif]

Bro make sure you aspirate (pull back) if you don't see blood push the shit in....no worries on the air at all!!!!

[mkrulic]

I think when you aspirate its more of a vaccuum then an air bubble

[jxlk]

ya dude. when u pull back u will see some air bubbles. but notice when you stop pulling back and let the syringe return to original position the air bubbles go right back where they came from. i get it all the time and never have any problems.

[joeyaaronson83]

Ok, and just one more question... If there is blood... Pull the needle out? Then is everything in the needle no good? Or do I just find a new spot that works and inject? I just don't know if everything would be no good if some of my blood was in it... And thanks again for all the help guys

[magic32]

Ok, and just one more question... If there is blood... Pull the needle out? Then is everything in the needle no good? Or do I just find a new spot that works and inject? I just don't know if everything would be no good if some of my blood was in it... And thanks again for all the help guys

The dose is still good.

M.

[c8rsa]

Maybe stick a clean needle on if you have to re-jab just so you know the area wont get infected. Dont re-use needles

[magic32]

Same dose, same pin, same body part, same room in the house, etc!

M.