sustanon.....crystals

[loki_is_a_god]

ok, guys and gals i just purchased some new sustanon....
i bought two bottles...they are under ground stuff...
the dosage is kind of weird 375mg/ml a little weird...
the next thing i noticed if i can see very small clear crystals.....floating around...should i be worried about this?
if i should be worried should i just filter both bottles or something like that....?

[lex57]

ok, guys and gals i just purchased some new sustanon....
i bought two bottles...they are under ground stuff...
the dosage is kind of weird 375mg/ml a little weird...
the next thing i noticed if i can see very small clear crystals.....floating around...should i be worried about this?
if i should be worried should i just filter both bottles or something like that....?

i would just try to run it under your tap water as hot as you can turning it side to side. its test and should have a low melt point i think its around 110degrees or so if i am not mistaken. your hot water should be around 130 degrees. it may take 5 minutes or so but it should turn clea. hope it helps

[loki_is_a_god]

i will try that....thank you lex

[lex57]

i will try that....thank you lex

sure thing, if it doesnt work repost here. peace.

[Ryanhallmark]

I would also agree try to warm it up. Let us know what happens.

[mkrulic]

warm it up but Id do it in a coffe cup. get the water boiling and then put the bottle in and let it sit. make sure the top stays dry.
this has the potential to crash again in your system. just because you can bring it into a solution doesnt mean it will stay that way. filter it again and that could help. you'll lose a little in the filter but whats not becoming a solution will be filtered out

[lex57]

warm it up but Id do it in a coffe cup. get the water boiling and then put the bottle in and let it sit. make sure the top stays dry.
this has the potential to crash again in your system. just because you can bring it into a solution doesnt mean it will stay that way. filter it again and that could help. you'll lose a little in the filter but whats not becoming a solution will be filtered out

if you chose to do it this way with boilng water then i would suggest a vent pin in the top to reduce pressure build up. its not really neccesary to get test to this temp but is a must with other compunds with higher melt points.

[juicedapple463]

hot water would be suffice for test, should clearup for you, let us know how it turns out.

[Drummerboy]

i would prolly dilute it with a little sterile oil. its crystalizing in the bottle because of the high test concentration. could turn out to be very painful once you inject it.