25 gaug

[marseea1]

so i did my first injection in my quad with 25g 1.5 in needles. obviously I only put about 1 inch in. but man it was very hard to inject the oil. it is test cyp by the way. I mean i really had to push and move the needle around. im sure it will be sore as shit tomorrow. are 25 guage always this hard? do i just need a bigger guage or is there something i can do? thanks guys

[Mammon]

go with 23G..

[D7M]

yep. 25g will take forever.

Mammon's right, go with 23g.

[lovbyts]

I actually like the 25g, I like the fact you cant just shove it in and they complain about a lump or how much it hurts for the next 3 days. I dont even force it with the 25g, I take over a minute to inject but I have never had a lump and only a little sore a couple times like I had bumped my leg.

[Rx GEAR]

23g x 1 1/2" are most common and almost always the way to go.

[Tigershark]

23g x 1 1/2" are most common and almost always the way to go.

This is what I use and have never had a problem.

[Barium]

23 is good to go. Might try warming up the shot a bit first if all you got is 25g. Will make it inject easier especially if its an oil.

[iPump]

25 is thin man. I run my oil under very hot water for about a minute turning the syringe about every 15 seconds to thin out the oil. Try to go for the 23s but if all you have is 25s then this should help.

[Mammon]

i use the 25's for water based stuff and my stuff thats 100% EO.
otherwise its 23G

[hankdiesel]

so i did my first injection in my quad with 25g 1.5 in needles. obviously I only put about 1 inch in. but man it was very hard to inject the oil. it is test cyp by the way. I mean i really had to push and move the needle around. im sure it will be sore as shit tomorrow. are 25 guage always this hard? do i just need a bigger guage or is there something i can do? thanks guys

This is exactly why I dislike 25g. I will only use them for my biceps, which I don't hit that often. 23g 1in for everywhere else.