drawing from multiple vials

[spiromik]

hey guys was wondering...
how do u draw from multiple vials in the same syringe?
i know how to draw from a vial when the syringle is empty...
how do u draw from another vial with a different compound. cause dont u have to push air into the vial so it makes drawing easier?

thanks

[Matt]

Once you have the required dose in your barrel hold it so that the pin is facing the sky. The compound will then fall to the bottom of the barrel , you will then have the air required for your next vial...

[lovbyts]

Yes I draw from multiple vails (3)
As said above. Dont force to much if any air into the vial or when you pull some will dribble/waste. It's better for it to have a LITTLE vacuum I think but if you like to do it the other way then make sure the pin is facing down so you dont blow out your gear and only the air.

[dec11]

you dont need to inject air in2 the vial, ive never done it

[panntastic]

just make sure you wipe the tops of the vials with a anti bac wipe you dont want a nasty infection and remember to change the needle its sure to be blunt after mutiple passes through rubber stoppers

[Knockout_Power]

there you have it, just keep the tops clean as mentionned and take your time, dont rush.

[Knowledge1st]

I have used a 5ml syringe if I had to draw from more than one vial, it creates more of a vaccume. I also buy a large supply of needles with no syringe, and use a sterile needle every time I draw, even if its with the same syringe.

[JScondition]

you dont need to inject air in2 the vial, ive never done it

You don't need to do it, but sometimes it makes it a bit faster.

Also drawing with a bigger gauge pin helps if you are pulling out thicker oil.