Ive just preloaded sum deca into 2ml barrel with a green pin. Deca is 200mg/2ml as its realy realy stiff in the barrel when i push/pull on the plunger what can it be? Cheers steve.o
Junior Member
Ive just preloaded sum deca into 2ml barrel with a green pin. Deca is 200mg/2ml as its realy realy stiff in the barrel when i push/pull on the plunger what can it be? Cheers steve.o
AR-Hall of Famer
It probably contains EO, which melts plungers and makes them stick.
Welcome to the Good Life
Didn't know that about EO..
Would it not be recommended to use EO in Test Prop for a "less painful" injection? Just saw a good recipe for this here..
About how long once the pin is loaded before it starts to melt/stick?
Junior Member
Well it appeared to happen instantly to my plunger. As soon as i loaded it it was stiff. Then put it in another barrel and same again
Member
Probably defect syringe. If it happened after you stuck the needle into your muscle then it may be scar tissue, happened to me too.
Banned
what size pin are u using.
Banned
green = 21 gaugeOriginally Posted by JP-MAN
Banned
I dont know the science behind this, but i find that if i heat the gear slightly when its in barrell by holding it under warm water then it makes for slightly smoother injection
Knowledgeable Member
As Dan said heat the stuff in the barrell,You can keep the pin on that you draw up with on and heat it in a jug of warm water 2 or 3 minutes then remove and dry and change the pin , When you heat the steriods the oil that its in heats up and the viscosity changes thining the oil and making it easier to flow
Last edited by scorpion62; 02-06-2012 at 05:07 PM. Reason: type o
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote