First Cycle - Test Enan only (questions)

[< <Samson> >]

This is what I got on order:

Clomiphene/Clomid 50mg x50Tabs
Tamoxifen/Nolvadex 10mg x100Tab
Test Enan 250mg at 10ml x2


I will be getting this from the most reputable source possible so I feel safe about the gear.

How does this look?

From what I have seen this should be a good setup in case I see any signs of gyno and covers my PCT.

I have been reading a lot and this is the best I came up with. My source says to throw in Deca into the mix, I say I should try test-enan only first.

Does this look like a sufficient supply of what I need for my 1st ever cycle?

Also, for needles. I figure a 22g to draw and 23g to inject < This sound good?

I see a lot of flaming on here and it does not bother me at all as long as it teaches me something that I did not know. This is not something I want to newb myself into.

[stpete]

Can you lay out your proposed cycle?

Test-How many weeks and at what dosage?

PCT- ^^^^Same.

And i prefer 18g to draw but it's personal preference.

[MickeyKnox]

stats?

[< <Samson> >]

Planning on 500mg(250mg on Wednesday & 250mg on Sunday) for 8 weeks

31, 185lbs 17%Bf

[gixxerboy1]

i would get an ai also

[DanB]

needs longer then 8 weeks

[DamageDealer]

you need to lose some weight. at 17% you're more prone to estro side effects of test, plus you'll get better results out of a cycle when you're lean to begin with

[MickeyKnox]

Planning on 500mg(250mg on Wednesday & 250mg on Sunday) for 8 weeks

31, 185lbs 17%Bf

drop some grease if you can bro. and run that cycle out ten weeks - you have two 10ml vials which is a ten wk cycle@250x2/wk

set yourself up with some aromasin(stane) as gixxer said. 12.5mg eod to start.

clomid nolva @ 75/50/50/25 and 40/40/20/20 respectively.

if you have hcg it's a wise idea to use this as well at 250iu 2xwk.

other than that get your diet squared away and solid w/o schedule and you're gtg.

[< <Samson> >]

Sounds good. . . As far as my BF%, I thought about losing some of my fat on a cut. But, I been bulking for a few months now. I gained about 5 pounds and I was thinking of running out the gear then going on a cut. Should I cut a bit then run the gear?

[JonnyConcrete]

I'd cut first mate, to under at least 15% BF preferabley 12

[MickeyKnox]

it's not wise to run gear with over 15% body fat and without a decent muscle base.

[bermich]

Run longer than 8 weeks. At least 10, ideal 12 to 14. Test usually kicks in at 4-6 weeks so right when youre seeing gains, you stop 2 weeks later?
Always recommended first cycle to use one AAS. That way you know which one is giving you problems if you run into problems.

[Brohim]

What are you going to eat on cycle

[< <Samson> >]

Sounds good, 15% BF sounds pretty good. I might be right around there now, I got my BF% checked almost a month ago. I was weighing in at 183 and was 17%. My diet and workout is pretty tight, I lost almost 2" in my wais.t since then and gained about .5"+ on my arms.

When I officially start the gear my diet will need to be tightened up even more. I want the most possible lean gains I can get. So my diet from what I read will need to be very protein heavy, high in cals and low in fat.

[funkymonk]

Run 10-12 weeks
Have an AI on hand
order an extra vial--the last thing you want is to be screwed over when you drop one, or they're underfilled

I draw with 22g and inject with 25g. Of course, I only inject .5ml at a time (TRT), so I'm not sure how long larger amounts will take through a 25g.

[< <Samson> >]

Very good point, spare on hand is a good idea.

Should I just get more test e? Or throw something else in the stack?

Really, a 25ga will work? The thinner I can use the better.

[bermich]

25 g is too thin IMO. Use a 23 preferably 22 or lower gauge. But if you wanna use a 25 and can squeeze it down, go for it.

[wesholcomb80]

I use a 18g to draw and pin with a 25g. I heat my gear up a little with warm water before I inject and it goes in smooth.

[< <Samson> >]

Good info, very good. . . I will be ordering aromasin, so it will be on hand with the rest of the gear before I start. I will also be getting another 10ml vial of test en. So, I will have plenty on hand to complete a 10 week cycle possibly a 12.

Should I run nolva & clomid at the same time for PCT? I haven't seen this mentioned anywhere before, I think.

[AD]

yes, pct is both clomid and nolva at the same time, 4wks each

[gmc2258]

Hi I am fairly new to the whole weight lifting scene but am wanting to drop excess fat and cut what I have. I have two 250 mg vial of test enan and 1x 100mg of stanozolol (winstrol) Ive never done a cycle my friend convinced me to start cutting up what i have. Im 26 years old work in the environmental field im heavy on the scale but ive always been i weigh 290 im 5ft 10 My workouts are mainly 30 mins of cardio (tredmill, stairstepper,etc) 3 days a week plus whatever I do at work I would say im in good cardio health as most of the day im in hot hazmat suits with a respirator on cleaning up bad stuff lol but this is what they said i should do on my first cycle they are both def reaping the benefits of there cycles theyve done i want gd results like them. Is this a good ten week cycle is it safe i just definitly dont want to have some crazy thing where i grow tits or somthing lol i trust my friends but idk i guess im just nervous being my first cycle my main goal is to slim my belly fat and tighten and cut all of my body thanks.

[gmc2258]

also they said i will be having to take clomid after the cycle idk how long but then id be off a cycle for 20 weeks is this right?

[bob87]

Gmc start your own thread mate with all your stats height weight bf% years training.

Don't hijack this one

[< <Samson> >]

Cool, everything is on order except I did not get another vial of test.

2 Vials of test enan
50 of 50 of Clomid
100 of 10mg Nolva
1 30ml bottle of Exemestane
25 3cc Syringes
25 18ga needles
25 23ga needles


I'm pretty stoked to see how this shit works. I always wanted to try this out but never took the time to research it enough and could never do my own shots.