While opening my amp the glass basically shattered. I have never had this problem before. I don't have a syringe filter. Any advice, so I know I'm injecting glass into me, and if I by accident I did. What would happen?
While opening my amp the glass basically shattered. I have never had this problem before. I don't have a syringe filter. Any advice, so I know I'm injecting glass into me, and if I by accident I did. What would happen?
LoL I have the same problem. I started my cycle with a 10ml vial, no problems, When that ran out i switched to amps. And never again. Each and every time a crack the damn amp little sand size grains of glass go inside the test. Drives me nuts. I won't use single use amps EVER again.
I'm fairly sure i've never injected glass however.. Just be careful man, Glass injected that deep into your ass probably is never going to come out.
I just hold mine up to a light, and draw the test out slowly and watch very closely that i don't allow any of the shards to go near the needle. usually its only like 1 or 2 small shards, sometimes a bigger piece so its totally possible to ensure you don't suck any up.
Also i draw the test in with an 18 gauge needle, Then i change to a 22 gauge for injection, Not much would fit threw the 22 gauge. You can see very clearly inside the syringe too to ensure that you don't have anything foreign inside. Just be more careful man. Take your time...
Can't you buy amp cutters????
Use a pen lid put it on the top and crack her open as for the shards try to hold it on a bit of an angle and use a smaller gauge needle
There are currently 1 users browsing this thread. (0 members and 1 guests)