Deca keeps fallin out! Is the ester still good?

[TT_Tweeker]

I know enough chemistry to be dangerous so help would be greatly appreciated.
I have some REALLY overdosed UGL deca that keeps "falling out" a couple seconds in a hot pan (with a needle in the stopper for aspiration) and it's g2g.
So, question is...is the ester still there or has it lost some and there for a much quicker half-life? As many of u could obviously see...I have no idea what is actually happening in the chemical structure. If someone could please help describe what is really happening here (in layman's terms) would be of great value.
Thanks in advance.

"RIP IT"

[Sworder]

Add more oil and solvents so it doesn't crash. The chemical structure is fine.

[TT_Tweeker]

BA and or BB. right? What is this and where could I get it? Also what type of oil?
Also when I have heated the vial for a couple of minutes...when u lift to eye level with some light in the background it appears to have a structure like when oils and what're r mixed. As if it still wants to separate itself?

[Sworder]

BA and BB and cotton or grape seed oil works fine. I believe AR-R carries it you will need sealed sterile vials and a syringe filter as well.

[TT_Tweeker]

Thanks sworder!
Man to tell u the truth the stuff was very affordable so I may just call it quotes with that vial. I'm getting in some test from bio labs this week. I guess I can just continue to heat until my t comes in. Had u ever heard of BIO LABS?

[Sworder]

Sounds like too much trouble, if you don't have the solvents on hand. Toss it.

[lovbyts]

get some EO, that should do the trick.

Dont vent it when putting it in the hot pan of water. You risk getting moisture in it and that may cause it to crash. If you want to vent it put it on a hot plate or pan on top of the stove. Let it sit longer, not just a few seconds but several minutes on a low heat not hot enough to burn it but hot.

[TT_Tweeker]

Hey lovbytes!
That kinda made me laugh a little
When I place it on a hot pan I do not add any water or anything to th pan. I have kept in on for several minutes as well. But I really do thank you bro! Nice pic man! Your avatar is sick bro!
What is eso though? Tip of solvent or oil?

[lovbyts]

OK got you. A lot of people put it into HOT or close to boiling water to heat it instead of directly on a pan or hot plate. I misunderstood and yes I have seen them talk about venting it even in an open container.

My bad, fat finger. I meant EO Ethyl Oleate. Some like to use it instead of GSO or other oils and it seems (from what I hear) helps hold gear together better especially at a higher mg/mL

[TT_Tweeker]

Man! Thank you so much!