Bit concerned

[Mrcivil]

Ok so I have a new source have heard he is reliable so I got test c and deca I'm running test at 750mg a week and deca at 600mg a week. I am mixing them in the syringe 1.5 ml test 1.5 ml deca so 3 ml total pinning quads. So my first jab was so hard to actually push the gear in feel like I was trying to jab concrete then was sore for the next few days. Thought maybe a one off but had my next jab today and same deal really hard to jab and now it is sore again I heated the barrel up this time to warm the gear but didn't help. I am a bit worried that I may have been burned I am getting pre cycle blood work back this week I am thinking of getting bloods again when I get the results so I can see if my levels are up at all. I have also been running dbol at 50 mg a day will this affect my test levels on bloodwork

[panntastic]

Does it go into the barrel from vial ok?
You should be able to tell by looking at the vial and giving it a shake to see if the oil is viscous or not.
As for the hard jabbing where are you jabbing?
I have read that when jabbing into scar tissue it's near impossible to push the plunger down.
I'm sure lunk started a thread on this

[Mrcivil]

Yeah draws up fine pinning quads don't think there is that much scar tissue. I just spoke to the guy he said a couple people have said the same thing about it he said it is the deca and that it is strong he recons reduce the dose a bit and see how that works. I'll get bloods done again they will tell me where my levels are.

Does dbol increase my test levels on bloodwork or not though

[lovbyts]

what size is the syringe, what gauge?
Also as said how did it load?
I have had some syringes that are just HARD to push anyways and it wasnt the gear.
It could also be whatever kind of oil they used. Maybe your old source used EO VS Cotton seed or Grape seed. The EO is a lot easier to push since it's thinner BUT it's more expensive so most people dont use it.

How fast are you expecting it to pin? Typically I pin SLOW about 1 minute per CC. The pain people get 9x out of 10 is from pinning to fast.

[Mrcivil]

what size is the syringe, what gauge?
Also as said how did it load?
I have had some syringes that are just HARD to push anyways and it wasnt the gear.
It could also be whatever kind of oil they used. Maybe your old source used EO VS Cotton seed or Grape seed. The EO is a lot easier to push since it's thinner BUT it's more expensive so most people dont use it.

How fast are you expecting it to pin? Typically I pin SLOW about 1 minute per CC. The pain people get 9x out of 10 is from pinning to fast.

Using 23 g needle to pin I think your right it might be the type of oil. I used to pin in about 30 secs but maybe I should slow it down see how it goes. It does draw up ok a little bit slower than other gear I've had

[lovbyts]

Mine draws up ok but takes 2x as hard to push.

When injecting thing about something. Fill your syringe with similar oil or even water. Now point it up towards the ceiling or ??? and push it with the same force you do putting it in you. Watch the stream shoot several feet in the air. Now where is that going inside your body? It's blasting against some poor innocent muscle. That is what causes most of the pain. You are bruising the muscle tissue. It needs to go in SLOWLY and have some place to absorb.

[songdog]

I have seen this before and they said it was scar tissue.Try pinning some where else Bro.