Results 1 to 14 of 14

Thread: High Hematocrit

  1. #1
    Join Date
    Aug 2015
    Posts
    120

    High Hematocrit

    I guys i am on 700mg of pharma test prop,first cycle 8 and half week in.

    6 week and half in my blood work show a hematocrit of 48.5

    now 2 week after my blood work show a hematocrit of 53.5


    i can't donate blood this month, if my hematocrit is increased by 5 point in 2 week


    is possible that after two more week on go to 58? another difference between test is that i start to take arimidex 1mg every 3 days.. and the week of the blood work i took 1mg plus because i see myself bloated.

  2. #2
    Join Date
    Sep 2012
    Location
    Scotland
    Posts
    16,515
    Your AI should have been used from day one.
    Lay out your full cycle for us you will also have to draw blood yourself.

  3. #3
    Join Date
    Aug 2009
    Location
    florida
    Posts
    6,646
    Quote Originally Posted by clarky. View Post
    Your AI should have been used from day one.
    Lay out your full cycle for us you will also have to draw blood yourself.
    Also 1mg of dex is ALOT!

  4. #4
    Join Date
    Sep 2012
    Location
    Scotland
    Posts
    16,515
    Quote Originally Posted by Sfla80 View Post
    Also 1mg of dex is ALOT!
    Sure is.

  5. #5
    Join Date
    May 2015
    Location
    Norway
    Posts
    7,469
    i didnt understand this..you took bw at week 6..then another bw two weeks after that....why did you do another bw so close?

  6. #6
    Join Date
    Aug 2015
    Posts
    120
    First week 100mg eod week 2 100mg e36hours from week 3 to now 100mg ed
    arimidex start from week 5

    i don't think i have ball for draw blood my self
    Last edited by gege2003; 09-27-2015 at 10:59 AM.

  7. #7
    Join Date
    Aug 2015
    Posts
    120
    Quote Originally Posted by Sfla80 View Post
    Also 1mg of dex is ALOT!
    i will cut half dose 0.5 e3day but i feel fine no dry joint..or anithing
    this week i go to far i had pain joint a bit.

  8. #8
    Join Date
    Aug 2015
    Posts
    120
    Quote Originally Posted by Silabolin View Post
    i didnt understand this..you took bw at week 6..then another bw two weeks after that....why did you do another bw so close?
    i don't pay for them.. simple as that

  9. #9
    Join Date
    Aug 2015
    Location
    Southeast, USA
    Posts
    2,042
    Quote Originally Posted by clarky.
    Your AI should have been used from day one. Lay out your full cycle for us you will also have to draw blood yourself.
    Clarky, Do you know the best way to draw blood yourself. I too need to draw some. Thanks.

  10. #10
    Join Date
    Aug 2015
    Location
    Southeast, USA
    Posts
    2,042
    At 26, first time cycling, at 700 mg a week of Pharmaceutical Test. I'm really not surprised that your Hemocrit level is so high. If you can't safely let some of your blood. You may want to end your cycle now and start a good PCT. If you aren't familiar with how to to run a proper PCT. There is plenty of good information here on that. Good luck, and be well.

  11. #11
    Join Date
    Sep 2012
    Location
    Scotland
    Posts
    16,515
    Quote Originally Posted by Strongblood View Post
    Clarky, Do you know the best way to draw blood yourself. I too need to draw some. Thanks.
    you will need,

    A. 5/32" OD polyurethane tubing, preferably clear.
    B. 18 gauge x 1.5" needle
    C. BP cuff
    D. 16 oz clear water bottle
    E. first aid tape (I use electric tape)
    F. gauze wrap

    1. cut polyurethane tubing to about 4 feet long.
    2. insert one end of tubing into the needle luer lock opening (should press fit), then wrap with tape to insure tubing stays in.
    3. poke two small holes in the water bottle cap, make sure they are smaller than the tubing so the tube press fits in.
    4. press the other end of the tube into one of the holes and secure with tape if needed, and leave the other hole open.
    5. put the cuff on but do not pump.
    6. find the vein and clean the are with alcohol few times.
    7. get a large cotton ball ready for after pulling the needle out.
    8. pump the cuff until you can feel the vein then with a quick move stick the needle in at a very shallow angle. remember the vein is only skin deep, so make sure you go in with very shallow angle. you should see blood shoot though the tubing and into the bottle. if blood slows down simply squeeze your fist every few seconds, if still slow you can increase the cuff pressure as needed.

    IMPORTANT!
    when pulling out the needle make sure the cuff is completely deflated, otherwise you'll bleed allover the place

    9. when finished deflate the cuff completely and pull the needle out, then immediately place a large cotton ball on the area and press firmly, rise your hand for about a minute or so then check and see if the bleeding stopped. add a new cotton ball then wrap with gauze for about 3 hours or so. this part is much easier if someone else does it for you.

    Good luck!
    Copied from bass

  12. #12
    Join Date
    Aug 2015
    Posts
    120
    Guys a little ot: Usually when size gain come? My trainer say that from now i will go like a weed

    but 9 week on test prop for my reserch is plenty.. I gained 20lbs my bench increase 50lbs my military press increase 15 lbs and every compound lift but the size is not there...inches are the same everywhere except on my belly, diet is spot on, I doing everithing in 10-12 rep. Any advice?

    For hematocrit thing i will have another blood next week if is increased, i have a friends who is nurse i will ask him.

  13. #13
    Join Date
    Aug 2015
    Location
    Southeast, USA
    Posts
    2,042
    Quote Originally Posted by clarky.
    you will need, A. 5/32" OD polyurethane tubing, preferably clear. B. 18 gauge x 1.5" needle C. BP cuff D. 16 oz clear water bottle E. first aid tape (I use electric tape) F. gauze wrap 1. cut polyurethane tubing to about 4 feet long. 2. insert one end of tubing into the needle luer lock opening (should press fit), then wrap with tape to insure tubing stays in. 3. poke two small holes in the water bottle cap, make sure they are smaller than the tubing so the tube press fits in. 4. press the other end of the tube into one of the holes and secure with tape if needed, and leave the other hole open. 5. put the cuff on but do not pump. 6. find the vein and clean the are with alcohol few times. 7. get a large cotton ball ready for after pulling the needle out. 8. pump the cuff until you can feel the vein then with a quick move stick the needle in at a very shallow angle. remember the vein is only skin deep, so make sure you go in with very shallow angle. you should see blood shoot though the tubing and into the bottle. if blood slows down simply squeeze your fist every few seconds, if still slow you can increase the cuff pressure as needed. IMPORTANT! when pulling out the needle make sure the cuff is completely deflated, otherwise you'll bleed allover the place 9. when finished deflate the cuff completely and pull the needle out, then immediately place a large cotton ball on the area and press firmly, rise your hand for about a minute or so then check and see if the bleeding stopped. add a new cotton ball then wrap with gauze for about 3 hours or so. this part is much easier if someone else does it for you. Good luck! Copied from bass
    Thanks Clarky! Sounds good to me! I think I will get everything ready and see if I can get a friend to help! Lol! Thanks again man!

  14. #14
    Join Date
    Sep 2012
    Location
    Scotland
    Posts
    16,515
    Quote Originally Posted by Strongblood View Post
    Thanks Clarky! Sounds good to me! I think I will get everything ready and see if I can get a friend to help! Lol! Thanks again man!
    Your welcome.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •